Waterproof Adhesive Apoxie Paste and Finishing Solution Bundle - Multipurpose Apoxie Waterproof Adhesive Paste, 2-Part Apoxie Paste 8 oz and Finishing Solution Cleaner 1 oz by Aves

I use several products from this company and recommend them to friends. This particular one is new to me and I haven’t tried it yet, but have several plans to test it out. I trust this brand.

Was easy to use and with clear instructions. Did the trick and now my hot tub filter cover clip is secure, even though it's submerged in hot water.

I am a sculptor who started to make "cores" out of regular expanded polystyrene foam, usually cut to shape with a hot wire tool. I started to use some Apoxie Sculpt by AVES for the armature-- which I cover with a thin layer of clay for the final detail work. Formerly I was using fiberglass resin over my cores, but that often melts and ruins the cores because fiberglass resin will destroy the cores. After looking around, I saw that AVES made this product, Apoxie Paste. I became very interested when I saw that it did not melt the foam. I was hoping for several qualities in this product. A liquid smoothability with self-leveling, quick drying time, and a hard shell that would not bend if you press down on it even if you put it on pretty thin. This product overcame all 3 challenges. The shell was not as hard as I wanted within 4 hours in the warm outdoor sun, but given a 24-hour cure it is exactly what I wanted (without putting a second layer on). It is somewhat expensive for such a small container, but it will cover approximately 4 cores making each core cost about 7 dollars which is minimal. If you are wondering about this product, you should buy a container and give it a try. I am very pleased with the outcome.

After years of using a very stiff paste epoxy, I finally ran out of it and had to find a replacement. From the description, this seemed to be about the closest thing to what I had been using, but it is noticeably drippier than my previous product. I like to be able to mix and apply right away and not worry about it dripping off my project--this one dripped. I suppose you could mix it and wait a bit until it firmed up, but that is not as convenient.

Worked very well for my project. Used a filler. Good viscosity for this job, not too stiff.

This product work very well for our custom trade show exhibit. We used this to help modify real tree bark on stumps that were custom made to look real. Used to fill in the voids and stamp the real bark in places that needed enhancement and painted to match.

The epoxy is very easy to use. It is great for filling cracks and can be colored for artistic purposes. The solvent leaked in shipping but the company immediately made things right.

I like this product but it is very sticky and difficult to apply when coating edges of a substrate. It dries glossy which is a nice feature but creeps under the masking tape and continues to slowly run and cures slowly so for me at this point there is some carving and sanding involved. I think I'll get its best application but still working on it. The videos aren't that helpful as to applications.