Dryrod DPC Damp Proofing Rods (50 Pack) - BBA-Approved Rising Damp Treatment in Walls, Stronger Than DPC Injection Creams. Coverage 6m

So much easier and cleaner than injection cream. Just drill, insert, done. BBA-approved, and covers a good 6 metres. Already seeing the damp fade. Great product!

Really easy to install but large bit required. You would need a corded drill really. I used my SRS drill. Did the whole job in less than an hour. Ideally for internal damp roofing but can be used externally as I did.

Like the product and is easy to install if you follow the instructions, I was lucky to have the right tools for the job , so far no damp but we will see how things go over the winter.

I bought this pack a couple of months ago. I had rising damp in both external and internal walls, most of which had already been treated at some time in the past, and re-rendered with sand & cement. I suspect that part of the problem was that in many places, the render had been applied right down to the quarry tile floor, which is a bad idea. I knocked off the first four inches of plaster/render everywhere, which exposed the lowest mortar bed.I firstly chopped all the rods in half, to suit the required depth for single-brick walls and drilled the holes in the mortar bed to the required depth. The sticks don't slide in easily, due to the ribs on them, but clearly that's intention and keeps them firmly in place. Some of them stuck out a little, but it doesn't seem to matter. All in all, it was a very quick process with no mess, (other than the mortar that was drilled out), and no waste.A couple of months on, the whole house has been re-skimmed and the walls are 100% dry. It is possibly a more expensive solution than the cream, but when the lack of waste is factored in, there's probably nothing in it.

Used these to treat a rising damp issue. Pretty quick to install. Need a 12mm masonry drill bit to drill the hole in the masonry layer, then use the dryrod hole clearing tool which gets out loads of debris and then slot the rod into place. Easy fit with the 12mm hole, just need to check with drill bit or hole clearing tool that all debris is out at the back as the debris, if crumbly, can block the back of the hole making it impossible to put the rod in all the way. Then just put some mortar over the hole and job done. Best to use gloves as the rods are a little moist, and the instructions do recommend this based on possible irritation from the ingredients. I bought the cutting tool too, which cuts the rods easy, maybe a sharp stanley knife would also do this but the cutter works a treat. Now it is a case of waiting for the chemicals to penetrate the mortar layer but am hopeful from all the online reviews and users that it will do the job once the rods are activated. Really simple job and really pleased. Would buy and use again.

Work well. Easy to do once wall has been prepared.

This system is ace, it's easy to do, very quick and effective and so much cheaper than rebuilding a D.P.C. The rods are better than the cream for older buildings as the cream runs away and you loose the important chemicals into your foundations.

Simple to install, just drill a 12mm hole at regular intervals (120mm) and insert the rod. I'm tackling the inner leaf of of a cavity wall and the rods can esily be cut in half to suit with a stanley knife.Time will tell how effective the product is in the long term but in my case the known damp areas are evidently drying out quickly. To begin with the walls could be seen to sweat out moisture and after perhaps a week become noticably drier... I have high hopes that along with clearing debris from the cavities this product will perform well into the future. I've only granted a three star rating for value for money as the future hasn't arrived here yet!

Sehr gut

Ho avuto l'opportunità di testare Dryrod, un trattamento anti umidità efficace contro la risalita di umidità nella mia casa in sasso, e sono rimasto estremamente soddisfatto dei risultati.Questi bastoncini anti umidità offrono una soluzione semplice ma efficace per affrontare il problema della risalita capillare nelle pareti interne. La loro formula innovativa agisce creando una barriera impermeabile all'interno dei muri, prevenendo così la salita dell'umidità e proteggendo le superfici dall'umidità e dalla formazione di muffa.Una delle caratteristiche più apprezzabili di Dryrod è la sua facilità d'uso. Basta praticare dei fori nelle pareti interessate e inserire i bastoncini anti umidità negli appositi fori. Non sono necessari strumenti specializzati o conoscenze particolari: il processo è semplice e alla portata di chiunque. Inoltre, non richiede manutenzione continua una volta installato, offrendo una soluzione a lungo termine per il problema dell'umidità.Ho notato che Dryrod offre risultati duraturi e affidabili. Una volta installati, i bastoncini iniziano immediatamente a agire, creando una barriera efficace contro l'umidità che dura nel tempo. Questo significa una protezione costante contro i danni causati dall'umidità alle pareti e agli interni della casa.Apprezzo anche il fatto che Dryrod sia disponibile in confezioni da 50 pezzi, il che offre una copertura sufficiente per affrontare anche le situazioni più complesse di risalita di umidità.In conclusione, Dryrod si è dimostrato un trattamento anti umidità altamente efficace e affidabile per affrontare il problema della risalita di umidità nelle pareti interne. La sua facilità d'uso, la durata dei risultati e l'efficacia nel prevenire danni causati dall'umidità lo rendono una scelta eccellente per chiunque cerchi una soluzione a lungo termine per questo comune problema domestico. Consiglio vivamente Dryrod a tutti coloro che desiderano proteggere la propria casa dall'umidità in modo efficace e duraturo.

No more mold so far. Did al lot of research and this is the best.

Barres efficaces, facile à poser soi-même, il faut attendre au moins 6 mois pour une bonne efficacité, franchement ca6marche très bien !!

Tenía humedades por capilaridad y han desaparecido después de poner las barras