hykolity 4FT LED Wraparound Light, 40W, 4400lm, 4000K, [2-lamp 32W Fluorescent Equiv.], 4 Foot LED Wrap Light Fixture, Flush Mount Office Ceiling Light for Garage, Office, Kitchen, ETL Listed

I like the great flexibility of the three color temperatures as well as the three power equivalence choices. I had the power coming in from the end so had no issues with mounting. The only downside is the diffuser; and since I only had to fight with it once (the power and color adjustment switches are on the outside), I didn't deduct any stars. But I would recommend any purchaser to practice putting the diffuser back on before installing the fixture because it takes quite a bit of finesse and it's much harder to do when it's up over your head. There was much cursing involved in my case because I was learning to do it while the light body was installed and I was reaching up over my head.

Worked great to replace an old florescent fixture. It allows for an off centered box and for the wires to be connected inside of the light which isn’t the case with the flush mount lights that are similar. It mounts with ease since it’s so light.

Great light! Very bright. Light weight. Perfect for closet !

The media could not be loaded. Overall it’s a great light. You aren’t going to get much change from the brightness adjustment but the color adjustments are nice and distinct. The 3000K is a nice warm color and the 5000k is basically pure white. The paper underneath is not too bad to work with. I think it’s a great idea to keep the wires tucked inside so you can’t see them on the cover and it helps directly the light out of the light fixture. The light is pretty lightweight. It is silent. I assume it has a cheap ballast because there is a 1 second delay from when you turn the switch on to when the light turns on unfortunately.There are a lot of unnecessary holes in the fixture so I used black gorilla duct tape to cover them and not let light through. I was replacing a light and needed to use the original hole placement which would be in the middle of the light. This light has LED’s near the middle so they put four mounting holes in the light to have them toward the sides instead of two down the middle. I drilled new holes taking my time to start small and go up in size, drilling from the inside of the light so I could see where the LED’s were. I used a regular framing screw as you can see in my pictures so the screw head was small. Because the LED’s are in the middle, the wire hole for your power wire is also off to one side and not the middle. But thankfully I was able to make it work using my original mounting location and hole for the power wire. I forgot to get a picture of the backside to show.

Exactly as described. Good light, attractive. Am purchasing a second one.

I bought these lights for my garage.Not sure how bright they would be.But these are the best lights I found for the price.They are amazing.I ordered an extra set!!

My old fluorescent lights went out. I tried universal LED bulbs and they didn't work. I assumed the ballast went bad so decided to change over to LED. I have it at its highest settings since I do a lot of tinkering in my garage. This light was super easy to install and is very bright. I am very satisfied with the light. There is one thing I would change about the light. When you wire it you can see the bundle of wiring when light is on. I taped my connection to the body of the light to minimize it. If the wiring isn't affixed to the center, then a shadow could be cast by the light.

When we first installed the light it appeared to be great. There is a slight delay when you first turn it on, but not terrible. it is bright. We didn't notice it during daylight hours, but at night time, this light is still on with a very low power.. almost light a nightlight glow. And that glow flickers. Very annoying! We are going to reverse the power wires white/black to see if that makes a difference. Our switch is NOT a dimmer switch, it’s a standard on/off switch.Edit to add: after doing some troubleshooting it appears we have a bad electrical ground that is causing the issue. When the ground was disconnected from the light, the light works great!