DERNORD240V 6500W Tri-clamp Foldback Heating Element Stainless Steel Immersion Water Heater with 3-Wire Electrical Locking Plug (1.5 Inch Tri clamp)

Like the ease of installing, cleaning, as it is on a 1.5 tri clamp ferrell. Plugs in from my PID controller with 10/3 SO cable. It is expensive, but for me, sealing the ends on a screw connected heater, time, components to buy, is not for me. A "elegant" solution.

This is a 120 volt element that takes a 240 volt twistlock plug. Was not expecting to need to get a 240 volt plug.

Works as it should

This element is awesome! Very easy to clean. Love that it has a Tri Clamp fitting and a twist lock for power connection. Easy to install setup and work with safely. Works perfectly with a PID controller. This was the biggest element available to fit in a 20 liter kettle. Very fast heat up comes to desired temp in less than 25 minutes.

Works very well to keep a glycol tank warm (105⁰).Would have been better if had the proper plug connector.

This coil heats fast. 6 gallon in 15 min. to start a boil. Solid, this is my second from this company.

I've had a lot of trouble locating the proper hookup for this element. It doesn't clearly state the type of plug it uses, FYI, it is L6-30. L6-30 is a standard locking plug for 240V, since this is 120V, it should be using a L5-30 type plug as that is the standard at that voltage. Would not recommend because of this.

Worked just like it is supposed to, I use it in a RIMS system for brewing and ave not been disappointed. Would definitely purchase again. I am running 120 volts instead of 220 just to limit scorching of the grains and as worked flawlessly, I have however ran this unit with 220 and haven’t scorched grains either just have to watch flow of wert prior to the grain bed settling, after that it was smoot sailing.

Attached with no leaks, heats a 30l still in about hour and half have been using for 4 months now about 50hr run time still working perfect.

Liked the fact that there was no fuss it does exactly what I expected it to do

Perfect RIMS heater. I run this at 120Vac btw. I also use one in my jacket water heater with excellent results.