Gasoila PLS2 Premium Pipe Thread and Gasket Sealer, -100 to 600 Degree F, 1 pint Can -PB16-N

Good product I also use it on on gaskets that may have to be removed from time to time not under pressure or indirect contact was gasoline or other solvents

I bought this because the company I had install a propane tank and lines at my house use it religiously. There are other types, some cheaper and more readily available (hardware store, Lowes, Home Depot, etc.), but I didn't need it right away.I didn't use much, so hopefully the product doesn't go bad. Seems to work great right off the bat.

I like it. Does what it says for intended uses and then some. Is it worth extra coin over stnd sealant? Hard to say, but I think so. Maybe not, but I'm gullible and the peace of mind I get from this stuff compared to other budget sealant...love it hands down. Worth it. ONE thing for sure...you will never use teflon tape [stnd, white, pink or yellow gas tape] again. Buy proper PLS for your application, use it properly and it wont fail. period.

This threadsealer has superior lubricating and sealing qualities to any other nonhardening sealer I have used (commercial marine and diesel use). I have used it on stainless, brass, mild steel, and aluminum fittings and bungs, for diesel, engine oil, (and even a few air lines). I have not experienced a SINGLE leak or weep yet. Phenomenal. Doesn't harden but can be wiped with a rag into a nice "bead" around the fitting, and then stays put.

Great stuff! Replaced natural gas fittings on water heater and oven. This probably overkill for that application, but would rather pay a premium for less hassle. No leaks. No problems.

Recommended to me by a gas appliance repair person. For good reason. The stuff is flat out the best stuff you can buy. Goes on smooth and seals perfectly.

This is what you need

the high temp.rateing!