Mini Micro Linear-Actuator 1.2" Stroke - w/Remote Control, 12V Force 64N/14.4lb, High-Speed 0.6"/sec, Small Electric Motion Actuator w/Mounting Brackets & Controller for Intelligent Machinery

Used to open and close trap door on a pull behind spreader. Works great. The challenge was to match the opening size with this device. The door was a 1” travel and this actuator movement was 1.2”. The other reviews noted the actuator would burn up if not allowed to fully travel. Took a while but came up with a scheme that worked. Very happy with the purchase.

Small in size but very strong arm power! Very happy with purchase. Easy to mount with brackets.

Product works great, no operational issues. It would be nice if a compatible harness plug and pins came with the actuator to avoid cutting the supplied plug off. Overall a good buy. Would buy again.

I used this Actuator to automatically engage and disengage the choke on my side by side with a gas Predator 420cc engine. I purchased the switch with it to make things really easy.

I used it to drop dry ice into hot water. It goes in and out with this actuator. Remotely. Worked, pretty fast, and has everything you need in one package.,

Works as specified. Nice quality with very little play. Have used it for a few hundred cycles without noticeable wear. Would buy again.

These actuators are supposedly rated at 14lbs, so I did not expect any problems with my application since it only required 1.4 lb of force to swing a hinged door. I was wrong. After a few cycles, the actuator began to make a clicking sound and could not fully close the door. I modified my design to have two actuators (double the actuator power) and after about 20 cycles, they failed as well. I took one of the actuators apart and found that they have very cheap plastic gears and the clicking noise was two of them stripping the teeth away very quickly. I can't think of any reliable application where these would work. Even a toy would certainly fail if a child actually played with it. Save your time and money - look else ware for an actuator.

Item is very underbuilt. The plastic rod end broke almost immediately. It's hollow inside of the body, and the material is so thin by the M8 male thread that there's almost no structural strength. Fortunately, the female rod thread is standard 8mm., so I was able to make a rod end, & am using it now. Not sure how long it'll last. I'll update this review if/when it crashes.

I used them on an Rc truck trailer

The actuator was small enough to mount underneath the air filter on a 22 HP stationary gas motor to operate the throttle control .The mounting brackets it came with made it simple to mount and when operated with a momentary switch it works 100% from 20 feet away.

Too small

perfect for what i needed. controlled via a 3-way toggle switch and powered with a 3s lipo. actuator can be stopped anywhere along the travel length.

Works as it is intended.