eleUniverse ABS Case with Heatsink & Fan for Raspberry Pi 3B+/3B/Libre Computer Board AMl-S905X-CC/ALL-H3-CC/ROC-RK3328-CC (Black)

Great all in one kit case and fan for the Libre Computer I've purchased. Case openings fit great and align great, and instructions included to help ensure on how to install the fan connectors properly. Fan is quiet with the Le Potato!

Minor fit issue with Libre Renegade, can be fixed in 45 seconds with a dremel tool with a carving end, you’ll notice that the IR sensor bulges out and prevents the chip from sliding into spot, mark where it is and dremel a small 1mm gouge into the casing and problem should go away, the bigger issue is with the bottom of the case having raised plastic area for hanging the completed case on a wall, those plastic bits push up on the motherboard and prevent it from being flush, cut away with a sharp knife or dremel them flat (I dremeled, plastic is super easy with dremel), now it fits perfectly!! 4/5 for modifications needed out of box but otherwise good case fits snug as a big after minor modifications! Hopefully they get rid of the bottom plastics and make an indent for the IR sensor, I’ve added red boxes around the photos where you need to remove the plastic, hope this helps!)

The quality of the enclosure is very good and sturdy, the fan is a little loud to be honest. The board fits nicely and it doesn't get too hot works great for my Batocera installation. The rubber pads and the screw holes are a nice feature to have.

Case is nice but the fan is crap. Noisy from the start, it died on me within three months.

Perfect fit for le potato boards. Seems well made, and I have not noticed noise from the fan that other reviews mention.

Time will tell if this actually does adequate cooling for my Le Potato, but installation was easy and mostly self-explanatory. I could've used just a shred of an instruction manual to show me which pin to plug the fan into (excuse me for being very new to the world of SBCs, but this is my first), but I was able to find someone with a similar case hooking theirs up on Youtube. As others have said, there's a large gap on one side, but this seems to be somewhat intentional. The Le Potato stays in place well-enough, though, and the case closes. Nothing shakes loose, so I don't really see that as a problem. The fan isn't nearly as loud as my laptop's, so I'm wondering if some models might've been defective. Mine seems quiet as a mouse, but I did end up with 2 leftover small screws in my bag. Thanks to having no instructions, I have no idea where they were supposed to go.

Easily assembled, sturdy, compact, and the Le Potato SBC fits in there perfectly. The fan is a little loud, but nobody has complained about their gift that plays retro video games just yet. This is my go-to case for Le Potato.

The case does not fit the board. the ports are off and the board does not sit flush. forget about using the emmc

If you are looking for vapourware than this is the product for you. It is very lite weight as well and comes in a bubble wrap envelope. But be careful when you open it as poof the vapour will escape leaving you with what appears to be an empty envelope. But don't despair cause Amazon does not have a category for empty packages or envelopes. Just gather up the vapor and carefully place it back into the package and return it.