MOTOKU Center Console Power Outlet Cap Cover Retainer Black for Chevy Silverado Equinox Colorado Malibu Traverse

Fits perfect

My 12 power port door broke off my 2015 GMC Sierria SLT and these are better that the OEM version. They have spring to keep them closed. They work great. Easy to install if you have to center console.

Great replacement part and looks OEM. The cover has a small spring and closes on its own.

This piece looks OEM when its in place. Has the same finish as my factory ones and has the same design cuts as my OEM GM ones. Good buy. I was super annoyed when I broke mine off. Glad I found a replacement with an extra to keep in the console just in case. This thing was a bit of a pain to install and figure out but its simple once you see how it works. Make sure you pull your console pieces off first, unplug the outlet, then take the silver outlet piece out before taking cover out of the trim. The tabs on the back inside of the cover are held in when the outlet piece is installed through the black plastic cover. Definitely worth the buy and would recommend this piece if it matches yours.

Does the job

Awesome replacement for my 2015 Chevrolet Silverado 3500 Dura-max. When replacing the units, make sure you feed the wires through the new unit. Plug it into the console. Then plug the wires into the outlet. Then plug the outlet into the hole. If you plug everything into the new cover ,you'll need never get it into the console and it sucks getting it all back apart without damage to the new part. All in all ,it's great to have the console looking like new !

Works great fit my 2017 3500 Silverado GM truck I do advise you to get the removal tool for your cigarette lighter adapter

These work very good and were a direct replacement for my 2016 Denali front console outlet. I was able to pry up my console front cover ( console lid to dash) enough to get my hands to the back of the outlet to disconnect the wire connector. I was then able to pry out the old door assembly with the outlet attached. There are two little plastic tabs that hold the outlet in the cover assembly that you have to release to get the outlet out of the cover. Once you have the outlet out of the cover assembly DO NOT put the outlet in the cover assembly yet. Snap the cover assembly in to the console and THEN push the outlet into the cover assembly. That will lock the outlet in the cover assembly and the cover assembly in to the console. Connect the wire and snap the console front cover back in place..

Fit and look just like OE.

Covers have springs to close.