LKS Replacement Blender Rubber Clutch Couplers (2) and A Spindle Tool SA9704230. Compatible with Kitchenaid Models Starting 5KSB3, KSB3, KSB5, 5KSB52 & 5KSB5

Easy to fit, using YouTube video!

Product does exactly what it promised. I have fitted it to my blender and it is working perfectly. The delivery was speedy and efficient. Only comment is that it was slightly on the pricey side.

Easy to install and does what it says on the tin.

Just what I needed, had my blender 25+ years striped the clutch when I left some hot water in the blender jar to clean it then tried to blend some soup. (People if that clutch gets too warm the gears will strip it will go soft and never recover) If you don't connect the blender to the gears just right the gears will strip and . . . these will save you blender. I an only recommend you buy a set now if you own one of these.

This does the job!Beware of online videos which show a variety of ways to remove the rubber clutch coupler. The included spanner makes the job simple, but the coupler has a LEFT HAND THREAD so be sure to turn in the correct direction (take a look at the thread in the replacement part).They always wear out eventually (sooner if you leave the jug full of hot soup on top) so getting two seems a good idea.Delivery was fine.

This is perfect for replacing the clutch on my kitchen aid blender. Unfortunately, after a lot of use, this part perishes, but this product is good value for money and works perfectly

Quite easy to install. Is it sturdy enough? After one usage, one of the "teeth" had sheared already.

the clutch unit is what it is, essential and expensive, but the spanner is a waste of time, could not get it to work, had to look at You tube to get the old one off. wedging it with a screw driver. If there is a knack to using the spanner perhaps the supplier could add instructions to the pack.