Multipurpose U Return Pipe Directional Pipe Tube 3/4'' ~ 1" Duck Bill Hose

The media could not be loaded.  I bought 3 for my Aqueon and Penn Plax filters because the outlets included were poor quality. I bought two sizes because I have two different hose sizes and both fit perfectly. I should add a hose clamp however I do not see the hoses coming off because they are on there really tight. It is really high-quality thick plastic not the cheap stuff that comes with the canister filters. You can tilt the outlets any direction that you want.

The idea, fit, and strength seem fine. As a matter of fact, I would love this if it din't leak. The seam at the hose barb (where you attach your tubing) is misaligned, creating a slow leak. Even when running just a trickle of water through it, the gap that is created by the misaligned plastic is big enough to allow water through. I tried with and without a hose clamp, no difference. Sanding the bump down may be a possibility, however it would mean sanding most of the hose barb down, loosening the fit and effectiveness of the hose barb further. It's hard to see how bad it is in the attached picture, but it shows what I am referencing.Edit: I have been in contact with the seller, and they have been great. It sounds like there was a bad batch or a small number of units that had the issue I described. It sounds like they are taking steps to prevent others from experiencing this issue.

Design was exactly what I needed but be warned, this is a great price but I’d have paid more for better material. Thinner plastic that begins to bend and warp when you are trying to slide tube onto rings, I very nearly crushed it into itself sliding tube on, and it was correct size tube. If you bend it too much it weakens the plastic and could cause a major leak in the future. :(

Need to drill a small hole in it to break siphon in case of a power outage!

Used for my 90gallon fish tank as an add on to the FX6