Waterproof Distribution Protection Box, ABS Plastic Breaker Electrical Box and Transparent Cover IP65, for Indoor Outdoor Wall Circuit Breaker (HT-2WAY)

This is a good option for an outdoor breaker panel if you use IEC style DIN-Rail mounted breakers. The manufacturer is very stingy on space inside. The 2-space box (Which I bought first) was too small for anything but a single very small breaker. I will always buy a bigger box than I need (At least 2 extra spaces)My box has 4 spaces, but the 2 outer spaces are partially obstructed by the cover screw studs so they can only accept small size breakers. My 50A 2-pole breaker is oversized so it could only fit in the 2 center spaces. I had to block off the outer spaces with a home made blanking plate. I wish the box included some blanks to cover unused spaces.The 4-space box has terminal blocks for Ground and Neutral and the extra space comes in handy to route the big #8 AWG around the breaker to the top terminations.Don't try to knock out the conduit holes with a hammer, you WILL break the box which is made of somewhat brittle hard plastic. You need to drill out the holes.The box arrived fast and was well packaged. It's an inexpensive and more waterproof alternate to a bulky metal NEMA 3R disconnect panel.

This is a weatherproof box with a built in DIN rail and knockouts for DIN mounted equipment. In the US we refer to this as a European electrical box as it is the standard form factor for breaker boxes over there. It very nicely and easily fit all of my meters and breakers. it is also one of the most inexpensive ones that actually seal well. i like the smoked access cover which also has a gasket. i am able to see the meters without opening anything.

perfect for my needs easy to install

Muy bueno de muy buena calidad perfecto así que cumplió con el objetivo que esperaba

Goo product. Compact for DC breaker and time delay relays for a generator start through my Victron Cerbo on my 5th wheel. Makes for a clean installation.

Using this for a 120amp DC breaker for a solar application. Works really well. Be careful when you fasten the cover. There are two sets of screws and both will fit the holes but one set is too short and will take some effort to remove! I speak from experience on this issue! Also, has a nice clear little plastic cover to keep dust out and cover the switch. Great for dusty environments.

Excellent

I purchased two of these units, one of outdoors and one at my solar equipment shed. The outdoors one seems to be keeping dry and works well. They are a bit limited in internal space with heavier wire, like #6, so would recommend getting a larger, maybe a four slot unit, for larger wire sizes.