2 Way Crossover for Speaker, 250W 4-12 Ohm 2 Way High-Low Frequency Divider for Speaker, HiFi Speaker Crossover

Good crossover. Works well for bookshelf speakers.

After discovering that my newly acquired Bose 601s had blown internal crossovers, I installed the DriSentri 2-Way Crossover set in each speaker. They were easy to wire and worked perfectly for my garage setup. The bass is punchy, and the crossover points suit the tweeters well. I didn’t expect much at this price, but I’m impressed with the value.

I used these to replace the 30 year old crossovers in my Boston HD10 speakers. I was just going to buy new capacitors and replace the old ones but the access point would have made soldering difficult and I am not that great at soldering anyway. These were just plug and play with no soldering needed. I just had to keep track of what wire went to what screw terminal and I was good to go. I clipped and stripped all the wires and easily unglued the old crossover and then with this item having holes for srews in each corner, I screwed it in place. I had recently refoamed the passive woofer for these and with the new crossovers, they sound like brand new. The crossovers have a switch that allows you to prioritize treble or bass with the crossover. With the switch pushed to the outside of the crossover you get more treble and with the switch pushed toward the center of the crossover, you get more bass. I tried both positions and I like the bass position best at least for these HD10's.

Good Value for low budget. Had to replace a woofer in a Rockville 12" PA speaker, bought this to replace original crossover at same time. Sounds much better

The Trebble is much louder and clearer the, my old crossover and theres no distortion or white noise at much higher volumes unlike my old ones, also the sound is more accurate and sounds amazing on my 50" loudspeakers, However I have to turn my bass all the way up to be balanced. But now it sounds awesome, update i turned bass management on in my computer setting and it fixed my low bass problem still no distortion but they vibrate my floor now 😁

Terminal blocks make for an easy install. Put these in a set of Klipsch KG 4.2. The original crossovers sat flat on the inside of the speaker, these did not due to the solder points. Had to use standoffs. No big deal as I just happened to have some.

Great cross did what is the post to do?My speaker much different Chris high.\nAnd the bass sound terrific.

Bought a used Peavey KB5 keyboard amp on eBay and found that the choke coil on the 2-way crossover network was cooked...it was a melted mass. Peavey no longer stocks replacement crossovers for this amp. I found this one and the numbers said it should work. It works beautifully and was a pretty easy fix.

Very good condition

Works well very happy

Ho acquistato i crossover per un mio progetto DIY e devo dire che sono rimasto piacevolmente sorpreso dalla qualità del suono ottenuto. Il rapporto prezzo-qualità è elevato. Consigliato

First off.....if you are unfamiliar with the idea of how a crossover works, and why, do not expect a random crossover to suit your speakers properly. The component values need to match, within reason, your speakers needs and electrical values. This requires a very complex understanding of many things. This particular crossovers values put quite a bit of mid to higher frequency, and volume, into the woofer, which, to my ears (depending on speaker components and values) suits Jazz/classical/etc type music quite well. Lots of clarity in the music. This may give the appearance of "less bass" on some speakers and to some ears and for some music. Again, this is extremely dependent on you speaker types, cabinets, etc etc etc. So far theses have definitely been a great buy for my situation.

Perfetto sia come prodotto che come filtro