FivePears Straight Router Bits 1/4 Inch Shank Double Flute, 3/4 Inch Cutting Diameter, 3/4 Inch Cutting Length, Used for Create Groove, Dado or Hollow

I bought this for one specific job that I figured would ruin the bit by the time I was done. It performed very well and didn't have anywhere near the wear/damage as I expected. I'm sure there are better but the 3" length is not a common need of mine and this was a cheap solution to my project - couldn't ask for anything more.

De muy buena calidad suaves al utilizar no se siente el esfuerzo al momento de trabajar

Very happy with the 1/4" x 1/2 shank bit. Have used many high dollar brands, this one cut clean and sharp. I was cutting about 72 pieces of Alder, groove was 4 inches long and 3/8ths deep each, worked perfectly

For $6ish, I can’t argue with the price. Cutting edge of bit appears to have chipped after about a month with maybe 10 bf ran through it. Maybe it was too deep of passes or maybe it was poor quality, can’t say for sure. Ordered another one because the price is excellent for what I need.

The bit cut about 5ft of only 1/8" depth before one entire blade broke off. Buy a different brand.

I've worked this bit hard for two days and it's still sharp and true with no nicks or chips. A good bit for a really good price.

Bought this bit specifically to rout (2) tracks for my crosscut sled’s runners to pass through on my DeWALT compact table saw’s foldable outfeed table. Worked like a dream! Order it now and you won’t be disappointed!

I’m very new to the world of routers. So I needed something to make 1/16 recessed grooves and I didn’t want to spend a lot of money. Bought a 3/4 straight bit and plugged it into my router, measured the depth and started cutting hoping my measurements were correct. The job turned out surprisingly well. Nice flat groove in my Mdf. Now if I could just get my countersink abilities up to par (kind of ruined the nice routing with a terrible countersink for the screws).