WiFi Smart Wireless Lights Switch Kit, ECO-NEWLEAF Waterproof On/Off Switch Compatible with Alexa & Google Assistant Voice Control Timing Function

This kit solved an obvious problem when we moved a doorway to the opposite side of the room. The wiring could not be altered without major work this resolved the problem and works really well.

These are amazing little devices, I have one in our bathroom so i can safely have a light switch near water and also in my shed where I don't need to run cables. I bought two so I could pair two switches to one device so either will switch on or off the light.

I thought this would be a great solution to control ceiling spot lights with Alexa. It was wired in and worked as good as I hoped with an Alexa routine plus the option of a remote switch as well.However after about 3 months the switch stopped working, the return window had closed and there was no way of contacting the seller

The product arrived in time but there is no instructions or manual at all. Packaging is nice and looks good too

Got this to operate a light outside my workshop from my house without me having to run wires for the switch.This is a great little combo of a transmitter and a wifi receiver switchSo the receiver can be wired in between the power wires for a light (as in my case) , which means that the light can be turned on in two ways , either by pressing the supplied transmitter switch( i.e. light switch) which generates its own small voltage to send a signal to the receiver to turn on the switch and subsequently the light , or as I have done you can add the receiver to your app on your phone in my case I use Smart Home and control it with your phone , you can also set a schedule or timer for it on the app to switch the light on or off etc . at different timesIt really is a great solution for activating a low power circuit ( 5 amp) without having to run wires , plus you have the bonus of having a physical switch you can use as you would for any other appliance it you wantWhats not to like ! 4 stars , ( it would be 5 if the operating amperage was a bit higher )I hope you have found my review helpful

So far so good, relatively easy to install. Both the app and the wireless switch work absolutely fine.Well built and would recommend.

The media could not be loaded. This novel design eliminates the need for batteries in the switch device completely.Essentially the push switch generates enough energy when pressing to power the internal 433MHz transmitter without the need for an additional power source. A burst of signal is transmitted on pressing the switch, which is picked up and processed by the receiver.Load rating 5A, giving about 1.2kw maximum capability and each receiver can accommodate 10 switches. A hard wired manual switch can also be supported at the receiver.Operating range indoors proved more than adequate for most properties, the switch worked in all parts of the building. Maximum distance tested being around 20mtr.Fitting is quite straight forward. Just a mains supply and a load connection to the receiver, the switch item is self powered.Once powered up, holding the pairing button puts the receiver in pairing mode, release and then just press the switch once and the system is ready to go.The power source for the receiver is derived from the mains input, which is switched through to also supply the load. The instructions point out the requirement for qualified personel to install the receiver due to the inherent risk posed when dealing with mains voltage.The instructions are printed in absolutely tiny writing which was difficult to see even with a magnifying glass in good light.This is a good product that is easy to setup and get working.

it worked brilliantly now it has failed says has 24 month warranty but there is no way to contact the seller thus making the warranty useless.