ESKONKERetaining Compound Green 603 Sleeve Retainer High Strength Cylindrical Metal Components Assemblies Locking and Sealing Anaerobic Glue 1.69 Oz/50 ml

worked well, as good as the loctite brand, and cost less

works well, very easy to dispense just the correct amount on threads. will buy again when needed. generous amount of product.

The purple does the job well on small screws

This thread locker seems to work, however I found it a little tricky and did not see any info on how to actually open the bottle ... first there's the main cap, ok just pop that off it is tight at first but simple enough right? well yes and no, as with most you have to pierce the nozzle to get the liquid to flow so I did that and it still was not dispensing any liquid.NOTE: Just in case others are unsure and have the same issue I did then the following info is for you.Then I noticed there's a spot that sticks out lower on the nozzle this is a secondary seal that you must pull up on to unlock it (See Pic), while this is great it would be nice if the info to open the bottle was included in the package. So unless I somehow missed it I did not see any ...Anyway with all that sorted the product works as it should and seems to hold tight and sets quickly, but because of the lack of proper instructions I am docking a star. O and yes as others have mentioned the bottle is half full.I checked the weight of the product and it is around 50g minus the weight of the bottle, so you are getting what they say your getting, its just in a large one size fits all bottle that they must use for all there products which in my opin is just ridiculous and one of the reasons for many bad reviews, they should really just use a smaller bottle for a smaller amount, but because you only use a drop or 2 at a time this amount is still quite a lot, and should still last a very long time.Yes I can recommend this product, as it does seem like a decent value, just know it will come in an oversize bottle, but they are not shorting you on the actual product.

Excellent lock threader

Works well and holds up to use. Applies very thin.

Was this as good as Loctite, sort of yes and sort of no. In the end it seemed to work the same. Took about 6Nm, give or take to get 6mm hex cap screws out and about the same for the ones I did with leftover Loctite brand I had.The difference was in how it went on. Loctite was a bit thicker and seemed less likely to run all over and drip off. Maybe just because it was older, I'm not sure. Overall though, I give it 5 stars for actually working and, as cheap as it was, seems to be a pretty good value for money.

This product is beyond good. Does as it says it well.