Wireless Charging Receiver,Nillkin Magic Tags Wireless Charger Receiver Chip 5W Qi Wireless Charging Standard (Type C - Long Version)

I have a OnePlus 6T. I bought it because it was mistakenly sold to me as having wireless charging, but I quickly found out it didn't. The rest of the features were nice enough that I decided to keep it, and this pad fills in that gap very nicely. It's very thin and has a thin ribbon cable with low-profile USB-C plug. While thin, a hard-shell case may not allow enough room for this to be used, but if you have a silicon case that is flexible, you'd barely know it was there. The ribbon cable connects to the jack at a right angle so that when it is plugged into the phone, the cable extends towards the back of the phone. The cable is very thin and all it needs is just a slight amount of flex from the case. The pad itself is very thin. When in place, the jack just barely extends past the opening in the case for the USB-C port, being almost flat. The case doesn't lay perfectly flat on the back of the phone, but you'd have to look for it to see the almost imperceptible bulge. All of my wireless charging pads work fine with it. The phone starts charging and I never have to plug in a USB-C cable to charge it. I have a wireless charging cradle in my car, and it works well in that too, letting me top off my phone any time I drive, or use the GPS with directions while not draining the battery. Pros: Works very well! Cons: Uses the USB-C port so you can't plug in anything else. As long as you rely on a phone case to hold it in place, you don't have to use the adhesive and it does unplug easily enough when you need to use the USB-C port, but still, you'll have to do that. Advice: Measure the distance from the base of your phone to the camera opening. Make sure you choose either the short cable or long cable. This cable length determines how far up from the bottom of your phone the pad will lay. You'd probably like it sitting closer to the middle, but don't want it to overlap the opening in your phone case or accidently cover up your rear camera lens. Make the measurement and check the choices to be sure you're ordering the right length.

Very good product it's so useful. In office and car travel time very useful

Value for money product

It works and works extremely well, that is not the issue. On my end I have a case. A slight issue of it not working on a hardened case like I have. The work around is that placement is on the outside of the case. Which looks funny in a way, but unseen in the holster. I did not use the sticky pad that came with it but did use double sided tape to hold it. As to connection.. it works great. My wireless charger picked it up before I even laid it down (Not like a foot.. couple millimeters), and charged fine. It plugs into the USB C, (Not an issue at all here), so it is proprietary to wireless charging when attached. Simple enough to remove for any wired file transfer, or charging from a wall outlet. This is also why I did not permanently attach it. Good durable quality. It was made properly and even had a beveled end for easy removal, rather than pulling on it from the cable. Good idea not to do that, by the way, on any cable attached to something. If you require a wireless charging pad to attach to a non charging setup, this works great for its intent. Just think about how it will be used with the requirements it allows.

Useless product. Refund is not allowed, the replaced product which was sent was also defective. Waste of money