🛠️ Elevate your DIY game with flawless edges that impress every time!
GSCIT Club White Melamine Edge Banding offers a 3/4 inch by 250ft roll of high-quality, flexible melamine veneer with a 0.6mm thickness and pre-applied hot melt adhesive. Designed for easy iron-on application and trimming, it provides durable, smooth edge finishing for plywood, MDF, and particle board furniture, backed by a reliable customer service guarantee.
J**N
Works and looks amazing
I purchased this when remodeling my kitchen to update my cabinets. They are older and had no trim on the edges. This stuff made them look new! It was so easy to use and made such a difference in the appearance. It’s been months since we used it and it still looks beautiful and has not broke loose. We applied it with a small heat gun and then trimmed any excess that needed it. I have also used this trim to redo a cabinet that was bought years ago and the trim had broke off and you can not tell the difference between the factory door and the one we replaced using this product. The adhesive works well and the price is great!!
K**T
Works great - fixed some shelves that were cut to fit.
bought this to fix some closet shelves. Easy to use and more than a year later - holding up, still in place. Looks good and works great
S**U
Pretty good, with a learning curve
The media could not be loaded. I bought an Ikea bookshelf to diy it into a pull out pantry door next to my fridge. It required me ripping the shelves down the middle leaving exposed MDF in edges. I planned to paint it but did an amazon search for alternative options and found this tape. I am not a professional so there are lots of oddities, like the shelves not winding up the same width, and of course MDF chipping from ripping with a saw. But back to this tape. No instructions came with it, which I was prepared for based on the reviews. I used my household iron and that there was some residue transferring onto the tape, and it looked terrible. Luckily, I was able to scrape it off and try again. I decided to use parchment paper as a barrier as I ironed on high heat. I had much better results. Also, nonpro tip: don’t try to tack one end then the other, then iron the middle. I found out again that the taoe stretches as you iron and caused a pucker in the middle, which puckered a bit. I was able to mostly iron that down to where it was acceptable without scraping that off too. About an hour total time and I covered 5 shelf fronts and two sides. It looks acceptable and I am happy with it. I may paint the chips or seal it with silicone calk. Overall I am happy with it. 4 stars since there are no directions n which would have saved some waste.
C**N
Easy to cut, easy to use
Our pantry has white shelves with white banding on the front, years of taking things off the shelves has taken its toll. This banding is easy to cut and easy to iron on and honestly putting them on has made the pantry look almost new again.
G**N
Is amazing product
I was preparing to hang some cabinets and needed to plane the last cabinet to the leat 1 point I planned in the wrong direction like an idiot and a piece of the front I was furious at myselfwent to the hardware store To look for stain, but most of them go on clear and no matter what I would do. It would never actually look right because of the jagged. Corner of the cabinet where the veneer was ripped off. I even tried wood pudding and it looked horrible. I was so excited to find a product that looked like. It might fix my cabinets Have an oak finish which has some variation in color this problem. This product is a very thick vinyl and very good quality. I took a piece of PBC lattice molding that I had primered I. Put the wood grain tape on the top, then folded it over so that the sides were also covered. I was shocked to see how well it matched. I put it above the doors as you can see in the pictures and Brad. Nailed it to the top of the cabinets. You literally cannot tell there was ever a problem? What an amazing problem. Whoever thought of this should get a prize. I am so grateful to have found it. My cabinets look amazing. It's very thick vinyl.The adhesion is great. I even took it back over to my local hardware store and the guy.Who usually helps me was also amazed.I brought pictures along and he couldn't believe it.It was better than anything else they suggested
M**.
cuts the edge banding really nice but.....
Got this trimmer today just in time to do some trimming but i am using 3/4 maple plywood and the tool does not want close that small but the description of this trimmer claims to be able but it does not .As a single sided trimmer works really well, what took me hours and lot of swearing, now it took minutes and is super easy.the seller says to E-mail them but what is your e mail i could not find it anywhere.
J**S
Size, Stickiness are good
It fit just right on the edges of my closet compartments. Easy to apply with a hot iron, sticks well.
M**I
Perfect for shelves
I didn’t even know this was a thing until I randomly came across it. The edging on our shelves fell apart years ago, and at first we used tape and then just paint only, but the unfinished edge is so obvious and ugly. This stuff is so easy! Just make sure you get the correct measurement. You can cut it if it’s not right, but I think its easier to get the right size at the start. Then just hold it down and use a clothing iron to press it down. It adheres right away, it’s so cool! No nails or tools required. Our shelves look brand new now.
Trustpilot
2 months ago
1 month ago