Thermalright HR-09 2280 PRO SSD heatsink, Double-Sided Heat Sink, with Thermal Silicone Pad for M.2 SSD Hard Disk, PC and Computer, Contains a Heat Pipe, Reflow Soldering Process

Installation was a Breeze on my X570 Motherboard. The quality of this unit is impressive, as for cooling without load runs at 29C. I have a basic secondary storage drive on it WD SN850 1TB, basic but still fast enough at over 4K speeds.. Thermalright is a Pro at this and CPU Cooling so I am not surprised at the quality and innovative design for this passive single heatpipe setup. Looks and Works Greats a wonderful combo these days for cheap money!

Ayudó mucho a bajar y mantener la temperatura de mi SSD, por lo que la vida útil mejora. Eso sí, es para una pc de escritorio y no para laptop, por si quedara duda.

Installed for 3 Kingston Fury drives in Dell Precision 3680. Temperatures under load are between 32 and 36C. This is after I already replaced the front chassis drives with quieter, but less aggressive Noctua fans. Highly recommended.

¡Excelente!

Somewhat exceeded my expectations, this SSD cooler is well built. It's keeping my SSD temps down considerably and looks good doing it. Only two issues I have are the included thermal pads are a bit tool far to one side to completely cover the last memory chip on the SDD circuit board but with the SSDs included graphene heat dissipation sticker it shouldn't affect the performance much if any. Also, there are no lock washers or teeth on the screws that hold the bottom plate on. This could become a potential issue as if the screws came loose it could allow the bottom metal plate to loosen and possibly contact components on the motherboard beneath. On my motherboard there are several small components just the SDD so making sure the bottom plate don't drop and contact them is a concern. I used some blue Locktight and made sure the screws were torqued properly so I should never have an issue but it's something to be aware of. Other than that, great product especially for how little it cost.