JDMSPEED 2 inch Triple Gauge Set - Oil Pressure, Water Temp, Volt Meter (Oil: 0-100 PSI, Water: 100-280F, Volt: 8-16V) - Fits GM, Ford, Mopar & More

Put it in a s10 it was cheap for the great quality of a product I got! I highly recommend it! The gauges in my old s10 weren't working and this helped so much

Came as pictured, easy to install on my 83 el camino

So disappointedWanted to put in my cutlassEverything worked fine for about 10 min. Then the lights flickered off and everything stopped workingI tried to use again nothing. Dead. Waste of money.

It is exactly as described. I used on my engine test stand, works well for that.

I have installed these in both small and big block chevy engines, the kit comes with all the fittings needed for my applications and probably any older American make vehicles. I am not a fan of the plastic tube supplied for the mechanical oil pressure unit, but it does work fine, just keep it away from the exhaust pipes! The lighting in the gauges is a little uneven, but functionally just fine, so if you are looking for impeccable looks, these aren't it . If you just want a low cost way to monitor your engine , these do a good job. These gauges are quite easy to install. A drill and basic tools is all it takes to do the job in less than an hour, if you know what you are doing!

This is nice looking set. It did not have instructions but I have installed many gauges like these before so I knew what to do.The Oil pressure gauge hole for the tubing to slip into was too small and had to be drilled out. The tubing needs to slip in a bit to keep the ferrule away from the end of the tube. Otherwise the connection will leak or even blow off.The Volt gauge electrical connections are very small. Hard to find terminals that are that small. You can wrap bare wire around the posts but that is a bad way to connect it. The mounting bracket comes very close to the terminals and I had to grind away some of the mounting bracket for clearance.The volt gauge reads .6 volts low.The temperature gauge came with an adapter that isn't any size that I recognize. It is too small for 1/2 npt and too big for 3/8 npt. Doesn't even match a metric pipe size. I had to buy an accessory kit for the right adapter fittings.The temperature gauge reads correctly at 180F but is 5F low at 195F.

Works perfectly, fine quality

Awsome gauges work great.