Nilight Motorcycle LED Turn Signal Lights, for Harley Honda Kawasaki Yellow

Bolted right up to my 2005 Suzuki SV 650 and after connecting the wires look great. They are very bright and what I like is that they are very small but durable. The previous ones I had were made of rubber and the rubber cracked and the turn signal was dangling. These units are aluminum and quite robust so I am not worried about them breaking under any normal usage.

Easy installation works as described

Worked well. They are small but the diodes are super bright so no issue. Easy to wire up and install

8 mo later

I bought these to replace the huge, garish trapezoidal directionals on a new CSC SG 250 (basically a Chinese clone of the Honda GL 250 series motorcycle.) Anyway, these directionals are very discreet, yet very bright. I had to fabricate some stalks to get them to stick out far enough to be seen by motorists in front or in back of the bike. But I was able to do this with other hardware parts from Amazon. The front two were plug and play , the back ones needed to have the leads extended.

Not what I thought. Super small, picture made me think normal full-sized lights, in reality only about an inch. Though feels quality.

Excelente producto

These aftermarket lights look awesome on my bike, super bright lights during the night and even the day. Really like how it only takes a 1/4" drill bit to install. If you want to remove for the track, buy 4- 1/4" plastic faring snap ins and hardly no one will know you had lights there.

Good quality, very bright

Good turn signals non-issue yet. You can buy the mounting bracket separately

Purchased with he rear set and drove once in the rain that wasn't even that heavy and there is now fog in both my left turn signals from moisture getting in and they intermittently stop flashing. Lights are not adequate for anything other than sunny drives. This was also my first drive with them at all so overall these lights are not what they advertise for weather proofing.

They work and looked good... but instantly stripped the threads when I went to tighten the nut