Baomain Red Sign Emergency Stop Switch Push Button Weatherproof Push Button Switch 660V with Box (10PCS)

Decent quality so far, it has a normal open and normal closed switches inside so you can set it up however you want. I used it to engage(turn on) a ac 230v 3 pole contactor($45 local) when the button is up, this setup will disconnect power to my 3 phase machining mill when the button is depressed.

Good quality

Installed on a Halloween prop. not done yet. We will see.

Seems to be well made and operates OK. If a person plans to connect a wire cable without an electrical entrance fitting, I'd recommend drilling a hole near the bottom-side of the unit instead of the center of entrance outline. This would allow the wire some room inside the housing to clear the switch when assembled.

Easy to install. Works great.

Exactly what I wanted works like a charm

Works great. I use it with the SainSmart CNC TB6560 Stepper Motor Controller with the NC terminals and it works just fine. LinuxCNC detects when it is pressed and when it is reset. Built better than I thought it would be considering the price.

This stop button is rated for 600v at 0.1amp and 240v at 3amp. Nowhere close to 600v 10a as the description specifies

Compared to my wholesaler is the price savings on this unit it was great. Used it have an emergency stop on the commercial drill press, work like a charm

Very good quality, great price, very fast delivery.Thanks!

construction is a little light and not very robust but it is ok for a light duty low voltage application for the price

Parfait

It works great I use it for my diy alarm system that runs on dc couldn't be happyer.