Perfit Liner 6 FT (72.7") Bed FRP Hard Tri-fold Truck Bed Tonneau Cover for 1982-2013 Ford Ranger Styleside/Fleetside Truck Cargo HardTopper (NOT for Flareside/Stepside)

Very nice looks good

This thing is great. It’s really made well. The extruded aluminum frame is really strong. The soft cover it very thick and strong also and the velcro it nice. Not the cheap weak type. Very easy to install and it fits perfectly. The clamps work well but I may drill through and put stainless screws and locking nuts but not because it needs them. Just because I prefer it.The only thing is, at first I thought something was wrong with it. Seems you can’t really lock the cover down if the tailgate if closed because it has a lot of tension on it. Just open the tailgate and it locks right down.

I have a 2008 Ford Ranger Sport. It fits perfectly. The instruction could be improved. In order to lock in the end cover one needs to pull the string and pushes top end part down to snap in place. My old cover I was replacing only needs to push the end part down by hands to snap right in which I personally would prefer.The clamps could be more sturdy and the screws of clamps need to be tighten from time to time until they finally settle. I thought the screws are little thin. I was afraid to strip or break them when tightening them.Overall, it looks good and in good quality. I would recommend it.

Cover came well packaged. I had watched a couple of videos on how to install, but the instructions were pretty simple to follow. I had to trim a bit off the two side rails as I felt there was too much tension when I tried to close and latch the cover. Once I did that it closed and sealed well.

The cover fit fine and looks great. The problem was the all thread bolts were to short. My 2024 has a cover around the bed top and the bolts have a hard time clipping under the rail

It was pretty easy to install. I was able to do it on my own which I appreciate.It looks so good!

Item is great A+++++++

Directions are a little sketchy and do not reflect the design of the side rails. The rails have a long lip that supports the crossbars, and that lip has cut outs for the clamps that are not shown on or mentioned in the instructions. The front and back clamp were no problem but the cutout for the center clamps was off position by almost two inches and at that location, the clamp could not be installed because of the layout of the wall of the bed. Simple fix with a hacksaw and Dremel tool and the center clamps are installed and rock solid. Overall appears to be well made and solid and looks great on the truck! Very happy with it.