Gaahing 4Pcs Peel and Stick Clear Corner Guards, Self-Adhesive L-Shaped Outside Corner Shield for Wall Edge Furniture Door Frame Protector Bumper (2.9ft x 1.0in)

These are just as expected, and get the job done nicely. Not much to say, it's a simple product that's easy to apply. Protects the corners nicelt.5

I got these to protect the corners from dings and damage as kids play a lot in the house and often ride the indoor bikes. These corner guards do not provide a lot of padding so if you are looking to baby-proof the house then this may not be the best one out there. I would still rate this good as these did the job for me.

I would recommend this product

These corner guards are highly effective at protecting surfaces from bangs and scrapes. They adhere well and fit snugly into corners, offering solid protection. The plastic is thick and crystal clear, with well-beveled edges that prevent sharp points, making them a great choice for durability.Installation is straightforward—just press them onto a clean surface after removing the plastic backing. However, be cautious with alignment, as the adhesive is very strong and can be difficult to reposition without causing damage. The 3-inch size is a bit short for some needs, and if you need to cut them, a hacksaw might be necessary.

The Gaahing 4Pcs Peel and Stick Clear Corner Guards are easy to use. Just peel the backing and adhere it where you want it. It sticks on well and stays on. It fits the corners well. We used them on the side of kids' trundle bed. They have fallen and hurt themselves a few times and this definitely helps. The edges are beveled and smooth and minimizes the impact with the bed.

We ordered these two protect our baby from the sharp corners in our house. They work very well and are easy to peel and stick on. I like that they are clear and don’t attract much attention at all.

Adhesive is reapplied, it's a bit hard to remove the plastic backing but after removing the backing installation is simple. Just press it onto a clean surface. Do be careful with alignment as the adhesive is very strong and hard to remove especially without damage for re-application. 3" is quite short, but if you need to cut it you'll probably need a hacksaw.

These are pretty nice corner protectors. They are smaller than other ones I have, but that is not a bad thing as they are a little less obvious. The plastic is a little soft as opposed to being a rigid piece. They adhere simply by removing the backing of the installed double sided tape. One thing that you need to think about is that the corner you put these on needs to be in good condition because the clear plastic will allow any issues to show thru. My other corner guards have been solid white and are able to hide the condition of an already dinged up corner where these will not. The clear is nice because it will blend in well and be a more subtle protection for your corner. Be sure to dry fit these where you are going to use them before you peel the tape backing and put them in place.