WE25X205 WE25M40 Dryer Drum Bearing Replacemnt Kit Contains WE12M29 Drum Drive Belt WE1M333 Drum Bearing Slide - Compatible With GE Hotpoint Replaces AP2619300,784658,PS267529

Works as described.

Great! Our bearing was worn and very squeaky. Get the felt and plastic strips for the front of the drum, too. They wear pretty quickly (speaking from a family of 7).

Just wrong all around. These parts are not even close to the original parts they advertise to replace. The screws are wood screws not sheet metal. The rear bearing has no slot for the clip that attaches to it. This design has the clip held on by a screw which the clip cannot attach to. The nuts that are supposed to hold the clip on to the screw don't engage the threads at all, just slips on/off with ease, wrong sizes. The drum bushing requires an o-ring to keep the plastic bushing on the shaft/stud of the drum bearing, there is no o-ring in this kit. So this whole assembly is useless without the o-ring. The screws are wrong also. It's a failed attempt at creating a very low quality replacement. Go back and do your research and redesign these items and it will be an ok inexpensive repair kit. Didn't even try the belt or the plastic slides. Which are all white in color. Original are white set and green set. They are two different materials hence the different colors. If you mix up the color strips and place in wrong slits of the front drum bearing assy you will damage your dryer. So having these replacements being both white it's a safe bet they are all the same material instead of two different materials as the original parts are. I wouldn't use these since they might damage your dryer. And the directions are useless. Very vague and skip steps. No pics to verify placements. The diagram of parts has no "alpha" descriptions yet in the directions they refer to an "F" part? Do better.

Great product, went in great. I wasn't expecting felt and plastic instead of rollers. What engineer designed this piece of crap. Built to fail. But your kit workers out great thank you 👍🏻👍🏻

Had to reuse a part of the assembly because the holes don’t quite line up from this kit. I also had to trim the plastic tabs to make them fit. At least my dryer is not longer making wildly loud sounds and works normally again.

Bearing kit worked well with the exception of the sheet metal screws. They are too big and when I tried putting them in the backer plate, one had the threads stripped the washer also has a very hard time threading on. Fortunately I had a small bolt/washer in my junk screw jar that fit but if I didn't, I would have had to go to the hardware store.

These are good replacement parts and do what they should and also easy to install! A few minutes of work saves you from having to buy a new dryer that may not work as good as your old one.

Nice little kit

Igualita a la pieza original

The bearing worked great all you need in this kit to repair you washing machine

"bearing" is of comically low quality. This is a product is of such low quality it is a waste of materials, time, and energy to produce. Absolute rubbish.