Standard 4/4X Mount for Starlink, Wall Mount Compatible with Gen 3, 47CM Mounting Kit for Roof and Eave, Includes Aluminium Adapter

I used this to mount my Starlink 4 onto a wooden building and it worked well. The kit came with long wood screws as well as studs for bricks so that was great. I took care to make sure that some of the screws went into structural timbers. You need to plan the order for installation think through the steps and make sure you have a long enough cable before you start and have checked the location with the Starlink app. So attach the base plate, making it as vertical as possible, then attach the upright to the base plate remembering to pass the cable through the upright before finalising the position as it gets hard to thread it through afterwards. Adjust the position to be vertical. Then attach top end of cable to the dish and clip the bracket into place. The tricky bit then to fit the dish on the top of the upright whilst pulling the cable through. A ladder holder is probably a good idea. Then rotate it so that it's aligned north-south. If you image skiing down the dish you should be headed due south. Although the app will check the alignment it's much easier to get it right first time. Then put in the final bolt at the top and tighten to fix the alignment.

Great bracket, solid,much cheaper than the original.

The kit comes with everything you need to fit your Starlink dish, masonry fixing bolts, heavy duty timber screws, coach bolts, 10mm spanner and even an 8mm masonry drill bit. Easy to assemble. The downside is that the angled post is very lightweight and isn't as long as the pictures indicate. To align the dish you need to select the holes in the post to suit. Its adjustment is somewhat clunky but fortunately Starlink doesn't require an exact physical orientation so will compensate accordingly. It's considerably cheaper than an official Starlink product although I suspect the Starlink one would be more robust.

Got set up behind a chimney and below roof ridge, Starlink works 10x faster

After researching the available Starlink wall mounts on Amazon I selected this one as it was well specified with quality materials. Installation was easy taking just 2 hours if you don’t mind climbing ladders. Ensure you feed the Starlink cable up through the mast for a tidy install. The instructions were mainly clear except for what to do with the rubber washers. I use them to pack on the gap either side of the mast. Highly recommended.

Excellent product with clear instructions used on our static caravan

Arrived promptly. Good quality. Does the job.

The product is well made but not totally suitable for mounting the Starlink to a wall. Even the longer end is too short to enable mounting at a perfect angle (if I try to tilt it back the top of my Starlink hits the wall) and the rotation slot is too limited for accurate alignment. I've had to accept a non-optimum installation.

The quality of the product seems ok. It included bolts and screws and drill bit for installation. However the arm is not as long as described, only reaching approx 450mm- not 600mm. Therefore not great for my intended purpose.

El producto viene con todo que necesitas para el instalación, tornillos para madera y con broca para concreto y tornillos para concreto. Muy buen equipo. Estamos feliz

Gute Verarbeitung, leichte Montage. Die Dish lässt sich schnell und einfach justieren und dann perfekt fixieren.

Buena Calidad.

Works great. Quick installation. Would recommend.