1/2 Inch Shank 45 Degree Lock Miter Router Bit 3/4 Inch Stock Joint Router Bit Woodworking Cutter Tool

Once you get everything set up it makes good clean locking edges with your woodworking. Better than others I have used at this price range. A good product to keep making constant cuts fitting proper good sharp cutters that I haven't had to sharpen yet.

I use miter joints pretty often, so I was greatly encouraged at the idea of doubling the amount of glue surface it such a weak joint. Unfortunately I have used a router very little, and a router table not at all. This is not a cut for a novice, there is too much going on at the same time. It does make the cut though, I cannot knock it any stars because it does do what it is supposed to. I hope to be able to use it effectively in the future.

The quality of this bit seems very good. I did use this bit, however it wold be helpful if they came with a setup block. The fit was a little loose but it glued up fine. Very strong joint.

Very nice router bit did a nice job, only thing that could make it better would be carbide cutters. The hardened steel cutters will not last very long...

Three stars can be a bit harsh for this cutter but since it failed due to my application I never got to test it for easier uses, I can only go by what I've experienced. The 45 degree lock miter bit can deliver a good locking miter profile but my application was a bit too demanding for a bit with a 1/4 inch shank. I needed to cut the lock miter in the end grain of 3/4 x 1-1/2 inch oak. I built fixtures to hold the material in the horizontal and vertical feed positions and they worked quite well with soft wood during setup cuts but the strain of doing end cuts in oak was too much and although I was feeding it very carefully and slowly, the clamp holding the oak work piece in the fixture came loose, the cutter grabbed and bent the shank. All in all, a combination of too little router power at the low speed I was running, inadequate fixture for the hard wood, and the 1/4 inch shank not being beefy enough for the task. I'm certain the cutter can do a good job running with the grain in soft wood as in the demo videos.

This bit works exactly as expected and saved my rear during a remodeling project. I used it to miter LVP around stairs as the stair nose system that came with the product was absolutely ugly. Basically this bit survived around 40 runs thru pressboard which is much harder than wood. I was really impressed! After those many runs with a hard material I would have expected to have to order another bit but nope! Still as sharp as when I bought it! Highly recommended!!

MADE IT SO EASY TO BUILD CABINETS FOR MY WORKSHOP... RAN THE WOOD THROUGH AND INSTANTLY MADE CORNER JOINTS THAT HAD NO GIVE AND WAS SOLID... A GREAT BUY FOR ANYONE WITH BUILDING PROJECTS THAT NEED JOINTS THAT DO NOT FAIL...

I used it to make some drawers. It's not Kreg quality -- but it is good enough for almost anything, and very inexpensive.

All good

Funciona como esperaba

It takes a few pieces of practise wood to adjust to proper cutting to match pieces properly. It would work better with its size to have four cutter edges instead of two which work OK. Problem with two is that plywood tends to break up quicker since there are only two cutter surfaces; therefore plywood layers fragment quickly. running slower starts wood burning. Over all a great idea.

Útil y práctico

Does seem to burnout quick if you are using hardwood. Otherwise it did as well as I expected.