YIHUA 8858-IV Multi-Purpose Heat Gun for Crafting Electronics Soldering DIY Shrink Tubing and Wrap Torch Marker with Temperature and Air Volume Control Function 3 Nozzles Manual Standby Mode

Please do not buy. Item does not work as intended and loses heat. Maybe it is just the one I received. I am not convinced this item is a quality item and suitable for professional use.Updating my review. Contrary to my first review. I am updating it as positive. The item works and works as intended. This is very useful for the DIY Electonics enthusiast to professionals. Operation is very simple and easy too.

Great for desoldering pcbs and also works well as adding direct heat to other things

This heat gun is quite a nifty little unit. It has a cable that is quite short, about a meter long, so I would advise you to use an extension lead with it.When powered on, the screen blinks two dashes until you press the small green power button. When clicked, it heats up speedily, easily reaching 450 degrees in less than 30 seconds. You can even see the heater emitting a red glow from within the cutout!As for fan noise, it was pleasantly quiet for what it was. Mind you, I had it set on 5 out of 10 fan speed, which can be changed. Since the fan is small, it does get proper loud once you set it to a higher level.Its not that heavy either, making work with it slightly easier. The handle is easy to grip and hold onto, and does not heat up with the heater inside. The small green buttons allow you to change the temperature by increments of 1 when clicked, or speedily increase / decrease when held. This unit can go upto 500⁰C and a minimum of 100⁰C.The build quality could be better however, as it does seem to be plastic. Its not the cheap type of plastic, rather the thicker and heatproof kind, suitable for handling the heater inside i suppose.I feel the value for money is something I can't quite comment on, especially as this is my first heat gun. But so far, so good! It did what I needed it to do; it got hot enough to melt solder points on a circuit board.I rate it a 4 out of 5. 😊

Very good heat gun, well worth the money compared to others on the market!Very nice speed and temperature settings too!

Handy little tool. Quite precise and heats to a high temperature. Runs quietly.

A great compact heat gun, the air flow is nice and gentle so doesn’t blow away your tiny components whilst removing or installing them and the adjustable heat is perfect for removing pretty much anything on a circuit board. Only gripe I have is that it doesn’t come in its own storage case (just arrived in it’s cardboard packaging) comes with a few nozzle attachments but I’ve only used the smaller one,All in all a great air gun to have that’s small and easy to use

I bought this to change a few SMD ICs, and didn't want to pay for a full rework station. I previously use d an expensive Metcal rework station at work and I wasn't expecting a professional level tool at this price, but it worked perfectly well with good temperature control and a decent selection of nozzles. Apart from PCB work, it's great for heat shrink and removing stringing from 3D prints. The one thing I don't like is the mains flex, it's quite a stiff PVC cable and too short for my setup. A longer silicone rubber insulated flex would make this a five star tool.

Works very well. No problem desoldering normal surface mount components.