Nilight in Channel Rain Guards for Chevy Tahoe/GMC Yukon/Cadillac Escalade 2015 2016 2017 2018 2019 2020 Original Window Deflectors, Vent Window Visors-4PCS

Exact and snug fit on my 2024 Chevy Silverado 1500 RST Crew Cab.These window visors are way better than the ones I already have but for different vehicle models. I have several installed on my vehicles all outside mounted using double adhesive tapes. Over time, the adhesive tapes will eventually dry out especially here in AZ, and will soon begin peeling off either from the vehicle's door frame or with the visor itself. Plus the double-sided adhesive tape leaves a nasty hard-to-remove residue from the door frame.These NiLight window deflectors (select fitment) are better.1. Easy to install inside the window rubber seals. Make sure to position the right visor first on whichever door you will be installing2. Visor for each window/door is longer, it will fit snugly in the window glass rubber seal. It requires a little bit of bending (don't worry it won't break) to get the visor fully seated inside the rubber seals. Make sure the windows are all rolled down. I decided to leave and not use the double adhesive tape on the visors. Once a visor is fully seated inside the rubber seal channel, you can tell that it won't easily come off even when driving. Plus, if you decide to remove the visors it would be easier not to get those tapes sticking inside the rubber seal.3. It comes with a dozen of metal clips. I used 1 each for the front visors and 2 each for the rear. Make sure to put the clips in an open rubber seal channel (gap) then push it gently using the plastic tool (crowbar) until you hear it snap into place.4. If you are installing this same as my vehicle, make sure to put tape beside the side mirror door rubber molding/seal where the visor tip meets with the end of the window frame to prevent it from getting scratched or peeled off during the installation. Once the front visors are fully seated and aligned, you can remove the protective tape by peeling it off.5. Final step - make sure to test windows operation by slowly closing then observe if the clips are in obstructing the glass from closing completely. My install did not have any issues except for the driver-side auto up/down at first the window bounced back when I rolled it up but after another test, it rolled up smoothly with no issue.It looks great on my truck. Like other reviews, the visor is a little shy of width.Overall, I am satisfied with my purchase of this product.

Fits perfect for my Chevy Trax 2018 and very easy installation, thank you, looks nice :)

Was too easy to install . Didn’t had to use the two way tape at all. But you can use if would like for it to stick on better

Works good but wish the tape was a little better. Do work tho

The rain guards over all are nice material but the clips they give wouldn't go into the to track to hold them in place and the lip curves in towards the cab so any rain just comes right in unless I crack my window only a quarter to half way down the rain guards. I've also cleaned when the adhesive strip goes countless times and I eventually had to go get some of my own

Fit perfectly. Ease to install

My car looks great with these. Easy to install.

This product should have been easier to install and took some bending of the product for it to fit my vehicle. Also, it did not stay in the opening of the top of the window, and the adhesive tore off when you went to peel the two sided tape. I literally had to use superglue to make sure that it stayed in the well of my window, however when rolling my windows up to secure it, it got on my tinted windows. Rain also drips in due to the poor fitting in the poor adhesive.