Solary Induction Bolt Heater Tool - 1100W 110V Magnetic Induction Heater Bolt Removal, Nut Buster Tool with 8 Coil for Rusty Screw Removing

Love it, nice case, heats up quickly and it's worked wonders for those tough nuts and bolts. Feels like it's built to last.

Works very well and takes about 30 seconds to heat a small bolt and close to a minute for a larger one. Good product and is easy to use.

Used this on my 2012 f150 front lower control arm replacement.It was nice not to have to drag my oxy tanks out.Worked like a champ and helped me through a tough repair.Ive worked as a mechanic for 47 years and never had one of these tools.Snap-on sells them but a price point that i did not want to spend.This tool was a good price came in a carrying case and worked like a dream.Thank you

I was very skeptical of this tool but it has been so valuable working on a rusty old Michigan truck. I did a complete exhaust system replacement from the manifolds back and I managed to get every stud out of a 20-year old exhaust manifold without breaking one. Invaluable tool. If you're on the fence, go for it. Also very helpful for removing the O2 sensors that were corroded into the cats. Only reason for 4 stars is I'd like if the loops that you can bend yourself were a little longer. It's hard to get a good induction loop and a long enough extension to get at those harder bolts. The tool is larger than I thought and kind of bulky so it's important that the induction attachments are long.

I got this product because I needed to remove a seatbelt clasp which was secured in the drive shaft tunnel by a caged nut. On top where the bolt protruded everything was pretty tight and I did not was to set my carpet on fire using a torch on the rusted bolt. That bolt was rusted to the max and I tried using a very long cheater bar on it but it would not budge. Next I used a hand held driver but it would not move after repeated blows to it. Then I read about this device and read up on the science behind it. In spite of the fact that some indicated it did not work I decided to give it a try because I had to get that seat belt latch out. I got it last night and got up this morning and prepped it. I got the more expensive version because it had smaller loops available. I got it in place and held it on for about 25 secs with my carpet smoking but the bolt was not glowing yet. I pulled out my cheater bar and applied some force and THANKFULLY it came out. I could have used my impact wrench but it was attached via a caged nut and I was afraid the nut would come loose from its 60 year old weld. So 5 Stars for this product because it worked. Most of the time a torch is fine but in some instances you don’t want to get your flame too close to a sensitive part.

These work awesome. Life saver taking a caliper rear brake apart that’s been under salt for 10 years. Worked so good I purchased another as a gift.

I bought this product in September of 2024. I used it one time to do cab mounts on my truck. It worked great, however when I went to use it again this past weekend for the second time, it would get bolts hot but not red hot. Very dissapointing.

For the cost this thing has saved me and some buddies many times well worth it! Highly recommended. If your a full time mechanic I’m sure there’s better ones out there but this has done everything I ever needed from small to large bolts only complaint I with the on off wasn’t a button and was a switch so you didn’t have to hold it while it’s in very minor change is all I’d recommend