Dremel GS45-01 Glue Sticks

These are sold in a 3-pack at a good price and the glue works well on my 3D printer.

These things work a charm and going on purple lets you see exactly where you've put the glue. I used these for a 3D printer and that said, I've since switched to a PEI bed rather than the glass one I had been using and no longer have need of glue sticks.I'd usually get a few/several prints off one or two applications but after a while the buildup affected adhesion and cleanup wasn't quite as easy as swiping the glue ON was.

I ordered these glue sticks to help secure my 3D prints to the build plate. Works like a charm. And the three pack was a pretty good value.

you my like this , my wife dont it wont hold

Great product for bed adhesion. Doesn’t take a lot to get good quality prints. Doesn’t leave much residue and easy to wash off if it does leave any

I’m brand new to 3D printing (literally used these glue sticks for my first print ever), so take this review for for what it’s worth.I’ve been printing ABS without a heated bed on my cube 3 and haven’t had any problems with warping or adhesion using this glue. I’m not claiming everyone will have the same results as me, but so far this has worked great (Note: I’m also NOT printing long flat pieces which I’m guessing will still warp?).This goes on purple, dries clear, and is easy to clean off when my prints are done. Definitely recommended!

While this may not work(haven't tested for other materials) PETG sticks very well to it.Clean bed while warm not hot, with water. Then one good wipe with isopropyl. Then let dry. Once dry do not touch, then add a single layer of this to it...let dry then warm bed up and print as normal. Do not touch.If you touch your finger oil will ruin it, and just a little touch is enough to mess it up.After printing you will not need to remove it, it literally pops off by itself once cooled. Again, printing dozens of prints with this stuff and PETG combo, and I have no issue with it.

I was having adhesion problems with my FLSUN QQ-S Pro. Many failed prints over the last month. I set the Z height too low, and managed to get adhesion, but it messed up my bed coating. I got a PEI spring steel magnetic plate, and even that really didn't help. Tried hairspray, no go. So I figured I'd try these glue sticks before I spent more serious money on specialty bed adhesives.Well, it actually works. The purple helps somewhat in knowing where you've applied the glue and where you haven't, but it helps more when a print is done and off the bed, as you can use plain hot water to clean the bed thoroughly, because the glue turns purple again when rehydrated. This is a huge help, as a clean bed, then glue application, seems to be what's working best for me.In any case, very happy and will be buying again, if the 3 pack doesn't last longer than the printer itself!