Radial engineering Catapult TX4 4-Channel Audio Snake (Trans-less) Module

Description

Product images are for illustrative purposes only. Other Catapult Series contents are included in the product images and description. Radial Catapult is a modular system that allows the transmission of four analog audio in a single LAN cable. What separates Catapult from other subsnake cables is that the terminal is a solid steel box (INPUT/OUTPUT module). On the transformer model, isolate can eliminate noise caused by ground loops and split signals. Catapult module uses common XLR terminals. The polarity of the terminals are Pin 1: Ground, Pin 2: Hot, Pin 3: Cold To allow for greater routing options, each module is equipped with two XLR sets. This allows the modules equipped with a transformer to be used as a standalone isolator. The Transformer model selects TX4L and RX4L models in the TX4M, RX4M or line level (+4dB) models with mic level (-30dB). TX4 / RX4 (Trans-less) Module To use Catapult, connect the TX4 on the transmitter and RX4 on the receiver side with a Cat5 or Cat6 twisted-pair cable. If you need a 48V phantom power supply to use a condenser microphone or active direct box, you need a shielded cable. While it does not require any shielding especially for line-level signals, the shielded cable is less sensitive to noise and is beneficial for all systems. Twisted pair is securely wrapped around a compact jacket to reduce cross talk TX and RX modules are equipped with 2 pairs of XLR to allow more distribution. This is basically a simple parallel signal so it can be used for a variety of purposes. Technical Specifications: Audio Circuit Passive Splitter Frequency response: 7 Hz to 20 kHz THD 0.0005% @ 1 kHz Dynamic Range: 140dB Gain: 0 dB / -0.8 dB Maximum input + 35dBu Minimum load impedance: 100 Ω CMR>103dB