WestbrassD271-NL-07 Velosah 9" 1-Handle Hot Water Dispenser Faucet (Tank sold separately), Satin Nickel

I purchased this faucet to replace a leaking faucet that continued to drip long after I stopped dispensing hot water. I have had an instant hot water now for 4 years and already had to replace the tubing that went from faucet to hot water tank due to tubing splitting. That was easy to replace entire tube from tip to tank but now it split again so I temporary fixed with splice but now issue was dripping always long after stopped dispensing.The faucet was so easy to swap with original one and longest part was getting under counter to loosen nut so I could remove faucet (corner cabinet and not much room to work in). In less than 20 minutes I had new faucet installed and no more leaks! I wish the tube lasted longer as it gets soft and then splits dumping water under the counter and I realize low flow from faucet. It is easy to replace tubing but should last longer than 2 years.Very happy with seller and was at a good price point (was considering whole setup was about 190) and will see how long before this either leaks from tube or does not "stop" flow fully.

The handle to turn it on is not in a convenient spot. One could burn their handSemi hard to install

Gets one star because it looks good. The valve keeps failing. Requested a replacement and was sent one but have the same problem. It constantly leaks. Will not order this brand again.

The hose from the water tank to the spigot of my original Westbrass faucet failed at the tank end. I thought I would just replace the hose, but it appears that the hose is an integral part of the faucet, so I had to replace the faucet. I ordered this Westbrass replacement for the one that I already had, but the design for the under-sink components all changed. I ended up having to do more plumbing modifications than I had planned. It was an awful big expense just to replace a lousy rubber hose.Overall, it is a high-quality good-looking unit. If it's a fresh install, it's all just fine. If it's a retrofit install, don't expect it to be plug-n-play from an older unit.

Very high quality, blown away with the value. Works better than the old model that I had for less than half of the cost. It had all the fittings, and connectors were brass, the waterlines are braided stainless steel.

When my hot water heater failed due to a leak after 5 years, I decided to start with all new components. The new faucet was designed with an easy to install bracket and threaded brass coupling to secure the mount to the sink. This mount is designed to fit a variety of sink and counter top thicknesses through a single hole. Flow is significantly improved over previous design.

tall spout, nice control handle, good flow

This fit right back where the other one was. Still NOT that easy to install, but worth it.

Voir plus haut.