1.5 Oz. Fiberglass Chopped Strand Mat - 3 Yards X 50" Wide for Hand Layup, Vacuum Bagging or Molding Composites with Epoxy, Polyester or Vinyl Ester Resins

It lays down good. I’m a beginner at making a motorcycle seat pan. Once it setups, trim before it’s 100% hard.

Put a hole in my boat so I started by fixing it using spray foam, one layer of fiberglass and resin, then I use two layers of polyester structural filler to make the surface level. I put three more layers on of fiberglass and resin, and then gel coat and it worked great. Not the prettiest but no water got in the boat.

Put a new wood floor on my boat floor, and this stuff with opoxy worked great, super strong and easy to tear, once cured, it feels super solid, and the amount that is comes with was perfect

Worked great for repairing my Sunfish.

It's fiberglass mat, so not a whole lot to say about it. I had read online elsewhere that you don't want to get this stuff if it is folded b/c fiberglass strands are strong when you pull, but break when you bend them. I could see where that is true with this product because the places where it was folded had some broken fibers when I unfolded it. However, I still used it and it still created a sturdy structure when everything was epoxied into place. For the price and speed, I'd buy it again.

For the price you get so much of this mesh that I had so much left over.

After my first order and application of this product I immediately ordered 5 more!!! This stuff is fenominal for glass work with epoxy and the only product that is available with powder coating! Yes it is messy and you will get strands everywhere but if you just score or tare it slowly it holds together fine. Also I have to say if you need to get 90% or just tuck it under it will comply! Just keep dab dab dabbing until the epoxy kicks and you will be just as satisfied as I am!

Exactly what I ordered and for a fair price.