Customadeonly 20mm Hubcentric Wheel Spacers 5x114.3 Compatible for Lexus ES300 350, GS300 350 430,IS250 300 350,LS400 430 460,RC300 350, Camry Highlander Tacoma, tC xB (4pcs 60.1mm M12x1.5)

Perfect fit on HighlanderGreat quality

Had my husband bolt them on. That way I know it was done right. He said it was easy peasy. My Lexus now looks awesome. Way cooler and more sporty.

these are good. lot of sketchy spacers out and i must say, but these are really good material. i trust them on my drift car not sweating these one bit.

hate having to run adapters this thin because the y inevitably come with super thin lug nuts to mate them to the car that are super easy to strip when torquing to spec. it's a real shame because everything else about the construction of this wheel spacer is well made. my advice is to take it slow and just be careful. maybe pick up some spares at autozone as expected wear parts.

Easy to install and definitely improved fitment. Make sure you torque to spec ~85 lb feet for the second gen Lexus

Really nice for my RC.

Very good fitment and complete.

So I bought the 15mm spacers for the front and 25mm for the rear of my GR Corolla. The fronts slipped on just fine and the wheel sat flush against them. But when I got to tightening the nuts that these came with, they are super short so as you tighten them, the head of the nut isn't deep into your socket, then it will round out the nuts because they're too short. Along side of that, the material they are made of is super soft so that doesn't help. My torque spec for vehicle is 76ft lbs and the nuts could barely handle that without rounding. I went out and bought White Knight 12mm-1.50 Open Ended Lug Nuts from Autozone. Part number is 213074 just in case you have a GR Corolla. I had to travel to 3 different stores to get 5 sets since they only come in packs of 4.I removed the nuts these came with very carefully so they wouldn't round out more and be stuck. I noticed metal shaving and broken threads fall out as I was removing them. Installed the new lugs and they fit perfect. They didn't round out or strip and they make contact with more threads so I definitely feel more safe.The only other issue I had were the 25mm rear spacers. They are the same hub bore measurement as the front, but yet they did not slip on like the fronts and when I went to remove the wheels off the rear to install the new lug nuts, the wheels were stuck on the spacers so tight I had to take a mallet and bang on the inside of the wheel to make them somewhat loose to I can pry off the wheel from the spacer. Both times installing the rear wheels, the wheel did not sit flush with the spacer like the fronts did, but once you tighten the bolts in the correct pattern, it will sit flat.Long story short, don't trust your life with the lug nuts these come with. And they should double check the measurements on the spacers.