Mini Skater 1 Inch Length Small Earphone Wire Clips Headphone Mount Cable Clothing Clip Earbud Clip to Keep Earphone/Microphone Cord in Place for 1.5mm Wire Diameter Round Wire Earphones,6Pcs (Black)

We installed these on some of our musician's KZ iems to keep them from tugging on their ears. They fit perfectly and perform just as I had imagined. Great value and product, excellent price. There isn't anything not to like about these. I am sure the fit on larger cords would be difficult at best, but that's not what these clips were designed for. They are meant for small thin cords for something more like a mic or iems. If you buy these with that in mind, you will be very pleased.

Works great to replace the clip on my earbuds. The part that goes around the earbuds cord is quite tight and perhaps slightly too small, as the hole designated for the wire does not allow the closing piece to fully close. However, the cord us secure and does not move. The clipping mechanism that keeps it on my shirt works great. I am happy with them. They keep my earbuds on my shirt. Great price

Got these for an inexpensive fix for my Bose SoundSport Wireless Headphones, whose cord clip recently broke off. Main body of this clip is sturdy enough for its purpose (even a bit sturdier than the Bose clip that broke); but although the cord hook on the clip would have been a great idea, none of its multiple "slots" are wide enough to properly fit the cord of my Bose headset (1st photo) Caution: If you force and pull the hook away too far to widen the inner hole, it would snap off. If you try and push in the cord to "snap" it into the innermost slot, you risk cutting or rupturing the cord's insulation. Fortunately, the inner cavity of the main clamp is big enough to safely accommodate the cord (last photo), essentially allowing you to just clip over the cord unto your shirt (thus ignoring the hook) to keep your headphones from falling off. The cord can still slide and adjust a bit through the clamp, but your headset will still remain secure on your person. In my case, I just created more of a "fixed fit" for the clip on the cord by gently pushing the cord into the hook to as far in as it can go (WITHOUT forcing it further than a slight "catch"). Then I secured the open side of the hook with a looped piece of black twist-o-wire/tape that was lightly tightened to just keep the cord in place without causing any damage on its insulation (2nd photo). For the size and construction of the main clip, and its price for a 6-pack, I found it worth the simple fix for my headphones, with a few more to spare.

Arching attempt at clips, these were definitely the better buy!

Nice, hold cord well ,but buy in bulk, should be called single use though, forget to unclip them and they explode. They are replace not repair.

These mini Skater Earphone Wire Clips are terrific. They are perfect for clipping onto earbud wires and shirts to keep your earbuds from continually falling out. Shipping was fast and they are wonderful. I would definitely order these again.

I prefer to use wired headphones but found when I exercise or work outdoors the lines can get in the way. The clips seemingly are no longer provided when getting a new phone or new earbuds and these work great at keeping the lines secured to clothing and reduces tugging and pulling on the earbuds. Also, since multiple clips are provided by this seller, misplacing one isn't much of an issue anymore. Well worth the price.

I like them, they work good.