WOOSTAR 10mm x 12mm Tie Rod End Replacement for 110cc 125cc 150cc Scooter ATV Quad 4 Wheeler Go Kart Package of 2

As other reviewers have stated, one of these tie rod ends is left-hand thread one is right-hand thread. Since I knew this going in, I purchased two pairs since I needed two right-hand thread tie rod ends for my Yerf Dog Spiderbox. These tie rod ends fit well, and appear to be better quality than the original tie rod ends from the kart which I replaced; the yellow zinc plating is also better. These have more thread, which was a benefit in my application.My only complaint is that I couldn't buy two right-hand thread tie rod ends to start with, but I ran into this everywhere I looked.After riding the kart for over a month with these tie rod ends installed, I am happy with the purchase.

Worked well for spiderbox yerfdog. Make sure you get 2 packs if using for yerfdog since you need 2 right hand threads. Same price as anywhere else. I kept the other for bushing parts if I ever needed.

This is an inner and an outer for either the left or right. This is not two outer tie rod ends like I was expecting. Unfortunately had to order 2 sets to get two outer tie rod ends. Good quality, just the only ones I can find that are 10-12mm.

Working good

Worked great on my g16 golf cart.

The Tie Rod ends fit my application just ok. The reason being that the Tie Rod ends that fit into the steering knuckles and on to the steering column were different lengths for left and right. This makes Castle Nut fit too far down on the shaft. The cotton pin holes were way above when tighten. The nut was down more that 1/2”.Seller should post the length of all major dimensions to aid buyers before purchasing.

Product was completely wrong I ordered tie rod ends which is what I got none of the bolts were matching one of them had washers the other one didn't and all the bolts were completely different sizes on both products

La atencion al cliente es muy buena, y mantienen iformado del seguimiento

None of the tie rod ends have a round metal clamp to hold the rubber boots on, But it allows you to correct the other issue. One of the 2 tie rod ends had no grease under the rubber boot, The other had a minuscule amount. I started by adding a small glob of molybdenum grease to the ball joints and some inside the boots. If you are replacing a decent brand of tie rod end then you may be able to steel the clamp from them. Can't say anything about long-term yet but without any grease, it would have been zilch. These value products can be stretched with some love and patience lol.

Good tie rod ends at a great price. I ordered the 10mm/10mm and they’re a fine thread: M10x1.25mm. Check the thread of your tie rods before ordering, some are a fine thread (M10x1.25mm) and some are an extra fine thread (M10x1.0mm).

Qualität und Preis hat mir gut gefallen,von bestellung an bis zum lieferung hat es auch Super geklappt, Zuverlässige Verkäufer

The media could not be loaded.  Wonderful price and super fast shipping thanks very much for a wonderful shopping experience ❤️

Utilisées sur des mini-jeeps en usage assez régulier, ces rotules chinoises ne durent pas très longtemps. Elle ne sont pas fabriquées en acier mais avec un alliage douteux (certainement à base de fonte), ce que l'on constate après des bris récurrents sur le pas de vis. Encapsulée dans une petite coque de matière plastique (pas du téflon !) qui disparait rapidement, elles s'échappent plus tard de leur logement après usure. A l'examen on constate qu'elles sont devenues ovales donc inopérantes et lâches, le fond du support rempli de poudre noire ! Pour allonger leur vie, on peut leur insérer un petit graisseur de diam. 6 mm.