Jabsco Manual Pump Assembly f/29090-Series

Works like a dream, glides smoothly,effortlessly!

I have a 1998 REGAL Commodore 258 with a Manual Toilet Model 29090-0000. The unit is plumbed through a saltwater seacock and is above the water line. The toilet is about 8-10 feet from the seacock. The problem was that the pump handle would not go up and down ... possible corrosion issues. Get some old towels out to absorb any liquids that might seep out. The first thing I did was unscrew the 6 screws holding the pump to the base (4) and elbo (2). They came right out. I used a long craftsman 12" screw driver. Thanks to a tip I read on another review. The unit comes with 2 important rubber seal/checkvalve type gaskets. No other parts were needed. The second thing I did was with an electric screwdriver loosened the stainless steel clamps. Third was disconnecting the existing hoses from the pump. Since the pump was now movable, is was easier to get the hoses in a position to twist and pull them off. Once the old pump was set aside, I poured 1 liter of water down the toilet water source input hose that is connected to the seacock to make sure there was a clear path to the bottom of the boat. The boat was up on a lift. Water flowed out at a steady rate. Next reconnect everything, and pour 2 liters into toilet bowl for a prime. Lowered boat into the saltwater, pumped about 6-8 times and water began filling in the bowl. Ran about 4-5 gallons through the system checking for leaks. Works great. Nice to have a functioning head!

El producto llegó rápido y está trabajando según lo esperado

Great instructions on how to install. I just installed this in my boat. It seems sturdy. I will have to update after using it, as my boat is in storage for the winter.

Easy install and works great!

Was having issues with the head on a 2003 Grady White 265 Express. The pump would exhaust, just not fill. Rather than messing around with the repair kit for $90, just spent the extra $30 and replaced the entire unit. Took about 15 mins to unhook the hoses, remove the screws and install the new unit. It works great now. Only issue I had is that my boat required a left 90 degree angle for the joker valve cover, so I simply reused the original. Would have been nice if the kit included both options.

I needed to replace my Jabsco pump. It was leaking around the top and the plunger was getting very difficult to work. I read the comments from customers and noted the one about the bottom connection was at a 45 degree angle up and theirs was 45 degrees to the left. I totally agree with this. All other connections were exactly the same. So I took off the connection and gasket from the new pump cleaned up the old one that was angled correctly and simply use the old one to make the connection to the line going to the tank. It worked great. So consider this as an option. Tks again to Amazon for this product.

THIS IS A GREAT PUMP