5" X 2" Swivel Casters Heavy Duty Polyurethane Wheel on Steel Hub Supports 4,000lb Total (Does Not Lock), Each Wheel Supports 1,000 lbs (4)

these are great casters that will support up to 4000 LBs. total. i built a platform and set my 6'-0" 10001b. bushhog on it. works great . i use a pry bar to get it to start rolling moves good on concrete floor. when i put on tractor i pull it to the garage door. makes it easier to hook up 3 point hitch being higher off floor. also i like the 2 zert fittings on each wheel for greasing. great product

These are quality wheels. But are also heavy . ( work good on my job site tool box. And heavy duty work bench.) I would recommend if you need heavy duty wheels.

Haven't installed them yet, but appear to be a perfect match to previously installed casters. Two grease fittings on each caster.

The order came early which was great! Product is good quality

Fast delivery!

I bought these to replace the casters on a Husky 84" tool box that came with PLASTIC wheels and soft rubber tires, one broke taking it off the trailer empty. These wheels seem sturdy and maneuver very well with a load but I only have about 1,000 pounds on them at this time. Eventually it'll be closer to 2,500-3,000lbs. I'll update this if handling gets hard with a full load but I don't anticipate moving this very often. Still trying to figure out how to mount a motor and steering wheel on it. (kidding)The only thing that strikes me odd is that the Zerk / grease fittings don't have a retaining ball in them. I'm not sure it really matters in this case since the ball-bearings are expose anyways. You can see them in the channel and grease them directly with a brush anyways.

They worked great.

I recently bought a HF Series 2 44" tool cabinet, but needed all four casters to swivel to improve maneuverability in tight confines. I took a chance on these and they are a near-perfect replacement for the non-swiveling casters that come standard on the cabinet. They are slightly taller, around 1/8", than the HF casters; however, that's shouldn't generally make a difference if you mix with the existing locking casters. Do note that these are not locking, my fault for not paying attention, will just need to swap one of the original locations to the opposite corner.