BBTO Heat Reflective Sheet Adhesive Backed Aluminized Fiberglass Heat Shield Tape Protection Barrier Heat Shield Resistant Material for Hose and Auto Use Heat Insulation Sheet(Silver, 48 x 71 Inch)

I situated this lightweight, heat-reflector material on the wall behind my toaster oven/air fryer combo where the heat vents are on back right side. I did NOT peel off the entire backing to expose the sticky -- instead I peeled off just a half-inch strip of backing to expose the sticky across the top and the bottom -- and then also added an X-cut-out for the oven plug to come through as well. My electrical outlet is just a fraction to the left of the oven heat vents, but I didn't want the outlet and the wiring behind/inside the outlet to get a constant dose of heat every time I used the oven, so I protected it with a small X-cut flap opening for the electrical plug to fit through. As a pattern guide, I first cut a paper bag the exact size of the reflective material and situated the paper bag on the wall to mark where the plug needed to come through -- this ensured where I needed the X-cut-out for the plug to come through. I then used the paper bag pattern to mark the reflective material and make the X-cut (and recycled the paper bag from there.) I kept the left and right sides open/no sticky used on the sides, so that air could flow and dissipate if there was any heat build-up. I also make sure the cord doesn't rest on the body of the oven when I use it. In my pics, it looks like the cord is touching, but it's just the angle of the pic, the cord isn't touching. These ovens get very hot. It all works well -- there is no heat build up behind the oven/on the wall/on the outlet -- as it reflects the heat away and it then dissipates all around and protects as designed.

Came rolled up with no creases. Easy to install. Worked great and stuck to the inside of side plate to protect against hot exhaust muffler on my 2001 Suzuki DR650SE.

I have a studio monitor speaker setup right next to my radiator. This stuff keeps ALL heat away from my speaker...its perfect. I've had it slapped directly on top of the radiator for the last 2 months without any issue.

I bought this to keep the direct sunlight off my starlink case. (I don’t have enough room in my service truck to keep it inside) the problem I was having was the case was getting too hot, in fact the satellite was too hot to even touch. I stuck the material, which is very sticky and will form to almost any shape. Now my starlink stays pretty cool even if my truck is under the sun all day

This works good for engine bay locations where radiant heat from exhaust can burn or melt hosed, tubes and wiring harnesses. Anywhere there is radiant heat within a few inches of wires, hoses or even pipes and cables. This doesn't necessarily insulate as much as guards against high heat components that can do damage. Tricky to work with as it in sheet format, sort of like thick shelf paper.

This product is ok, but it doesn’t come on a roll like in the picture. That means when you apply it, there will be crease’s. Will be sending back for this reason.

This adhered well to the ceiling and covered the area nicely around an exhaust vent

Great insulation!!! Made garage extra 10-degrees cooler than outside compared to last summer. And it was hotter this summer too!Easy to apply with very strong adhesive! Plan your installation, cut into proper sized pieces beforehand. Be extremely careful when peeling off backing because if it sticks to itself, it WILL NOT separate. You'll end up tearing it trying to separate. I peeled and laid it upside down over arms of chair in preparation. Then gently lifted by corners to keep sheet flat and then slowly moved to garage-door panel to install.Overall, took about 1-hr to install on 2-car garage door. Really amazing performance at keeping garage cooler. :)