New Rage Cycles Fender Eliminator Compatible with Triumph Bobber (2017 - Present) Tail Light Only

This is one of my Favorite add-ons to my 2022 Triumph Bobber. The box came with everything I needed and the install plans were easy to find on the new rage cycles website. I also found a YouTube video on how to install it. It only took me about 3 hrs to have everything installed. The one weird things is that the directions say to take off your left side airbox, and I didn't have too. I'm super glad that this worked on my 2022 Bobber when the site info says that it works on up to 2020 Bobber so that should be fixed. Anyone who gets a Triumph Bobber needs this kit. Thanks alot to New Rage Cycles for making this great product.

Love it very cool super clean much better than stock.

Hello everyone,Delivery: very fast delivery from USA to France via DHL: ordered on Sunday and received on Wednesday. Consider additional cost for customs around 30$, so finally you pay 220$ part + 55$ shipping + 30$ customs (DHL is sending you a message and invite you to pay the customs cost on their website).Assembly: around 7hours. I didn’t have any tool to remove the wheel, so I did without removing it. Just by moving the mudguard (after removing the screws of mudguard), you can’t remove the mudguard completely by the top. I took also the existing wireharness protection which goes through the mudguard protection and put the licence plate light wireharness into it. The work instructions are on the website of New Rage, they are not delivering it with the kit. It is detailed but I expected a bit more advise especially at the end when all cables are connected you have a lot of cables length remaining, so I didn’t know where to put all these cables and where to place retention collars. Finally I followed my feelings and knowledge.Quality of the kit seems good, I hope that the rear light has been designed enough sealed in case of rain because when I screwed the support on the seat, I had to force a little bit during screwing because the bending of the support didn’t fit 100% to the shape of the seat…Of course when you power on the turn signals it blinks quicker than before. To solve this you don’t need to buy resistance, simply following the procedure on board computer of the Bobber and apply “type 4”, then it will blink normally. See attached picture.Finally, many thanks to New Rage to have developed that product for the Bobber. Simply because for a long time I am searching solution to have a better rear look while remaining “legal” with a good price. This kit has everything in my opinion. I directly ordered then the 360 front turn signals 47mm, which are working also fine.You can have a look on the pictures attached ( yes …. the licence plate is big… it is the legal size).Please be indulgent regarding how this rate has been written, English is not my mother language …Best regards

Señores el pedido no ha venido completo le falta un adaptador de un conector, no puedo usar mi moto porque está desarmada y no la puedo armar porque falta ese adaptador no vino en la caja (adjunte foto de lo que falta)

Easy installation. In a couple of hours I was ready.

Very cool product!

Good build works great! Cable management could be better. Had to drill seat pan to make it look cleaner. 4 out of 5 because instructions were pretty bad.

The Light unit did not fit the seat correctly, hole did not line up. Indicators flash too fast, no resistors supplied or recomended in the instructions, Stop/Tail light failed after one day in use.