🔋 Power Up Your Performance!
The Dell PowerEdge 1100 Watt Power Supply is a renewed powerhouse designed for compatibility with various Dell server models, ensuring efficient and reliable performance with an impressive 80 Plus Platinum rating.
| Brand | Dell |
| Series | prime |
| Item model number | YT39Y |
| Item Weight | 2.57 pounds |
| Product Dimensions | 8 x 5 x 2 inches |
| Item Dimensions LxWxH | 8 x 5 x 2 inches |
| Power Source | AC |
| Manufacturer | Dell Computers |
| ASIN | B07DX73NHW |
| Is Discontinued By Manufacturer | No |
| Date First Available | June 21, 2018 |
A**Y
Working great! Surprisingly quiet.
Using as a high amp bench 12v supply (instructions below). As other reviews mention, it’s hackable, but the info can take some digging to find. Fan only runs as needed, for my uses (up to 30a continuous) it’s rarely above idle. It will rev up like a jet engine when first powered up, but quickly slows back down. 80plus platinum makes a big difference I guess lol.To power on the supply, place it on a bench with the label down and connector near the top (ignore the label if unsure and go by connector position). In this orientation, the 2 small tabs closest to the end of the connector are what you need. Solder them together, and run a little jumper wire to ground (add a power switch to this wire if desired). The big (power) tabs are as follows, starting from the one closest to the little tabs: 12vsb (low power, generally not used for DIY), ground, ground, 12v, 12v. These tabs are connected directly to the matching tabs on the other side of the connector, the little ones are not.
F**Y
ive got the power
great value , bought two. both work perfectly . will buy from again .
K**K
well packaged referb part.
This was a well packaged referb part worked as expected. The only down side is the description could be improved by stating its the older part not a new style EPP version.
C**N
Works Well
Very good quality. Puts out clean 12VDC 91.1Amp power. Great for diy power supply with better specs than more expensive types.To turn on all the time, connect pins*:13 and 14 to each other (solder blob)Then (13-14) to (16)To use a SPST switch to turn it on/off:(13-14) (solder blob) to one terminal of the switch(16) on the other terminal of the switch*Pins are on the bottom (non-label) side.13-14 are the right most pins on the bottom. 16 is the 4th in from the right on the bottom.The main power output pads looking at the top side are:(+) is the left large pad. (-) is the right large pad.
A**A
Customer service department not helpful and not service oriented
My customer service experience very poor and not helpful at all. I believe product is good, but I would buy the product somewhere else where can get much better customer service.
T**G
hackable like the HP version
with a couple resistors this can be turned into a hobby power supply. lots of power small price.
M**E
As advertised
Works fine, recognized by iDRAC. Good price.
A**R
Good
Excellent
Trustpilot
3 weeks ago
2 weeks ago
