Junction Box Outdoor Waterproof IP68 Electrical Cable Connector 2 Way M20 Plug Wire Range 5 to 12mm External Cord Boxes 2 pcs

These worked great for hooking up a pond fountain with the electrical connection under water. Easy to hook up the wires. Works great!

This splice kit works great! I use these to repair extension cords. I also used this to repair my vacuum cleaner power cord.

a squirrel had bitten through an outside electric chord and i needed a water proof splice. this worked wonderfully. was easy to install ( you will need a pliers, #0 phillips sscrewdriver, utility knive, wire stripper and optionally electrical tape). there was 2 bites in the chord to fix, it took me about 30 minutes to fix both. I was especially pleased that they include a second set of washers for a thicker chord, which i needed to use. overall, this did the job perfectly. I then wrapped the chord in a protective sleeve to hopefully keep the squirrels at bay!

Overall I think it is going to work pretty well as an inline splice; however, it wasn't the easiest to use. If the connectors were just a tad bigger it would make a huge difference. It seems like they are sized for 14ga-16ga wire whereas sizing for 12ga would make it soooo much easier to work with.

This product works as advertised, nice, neat and small, help me repair the torn electrical cord. Love it.

These are used for joining two bare end power cables together. You can easily cut and rejoin a 110v cable with one of these. The adapters fit up to four wires, which is interesting. I used one to run a power strip cable through a hole in my wall into my closet so I could put all my Internet devices inside the closet (modem, router) because the cable installer ran the coax for my cable modem into my hallway closet through the floor.I bought a high quality surge protector power strip on Amazon, and clipped the cable about 3 ft from the power strip end. I drilled a hole through my wall from the outside (where the wall plug is) and fed the bare end through the hole into the closet. I installed this adapter between the two bare ends, to rejoin the power strip.The cable on my power strip is pretty fat and this thing still worked very well. Eventually I will have the cable and everything tidied up on the inside and outside of the closet once the cable tidy kit arrives.

Easy to use water proof junction box

Very difficult when using 14 Ga. wire and difficult to tighten screws. Screws need (No. 1 Phillips tip) which is too small and can't torque screws enough. Also too many components to the connector and make sure you have enough room to assemble it together, you need plenty of slack in your wire. It would also be nice if they added numbers or marks to the wire slots to make sure of your wire codingMaybe I'm using it for the wrong application (In-line splice for 110v 3 wire power cables) but, I made it work, now lets see if it stays together on the road.