BlueStars WB16K10026 WB29K17 Double Burner Assembly Replacement - Compatible with G.E Kenmore Hot.point Ranges - Replaces 868697 AP2633210 WB16K10003 - PACK OF 2

I needed this model reference because mines were broken, it fit really well, it is still working after almost 2 years. Recommended!

Exact fit with no issues

The included spacers were required, but fits as well as the obsolete factory dual burners which were rusted thru. Opted to try these dual burners assemblies since the advertised dimensions matched the old Whirlpool burner assemblies (9" center for the Gas spuds / orifices), and the spacers could compensate for height difference of the electronic ignition platform and center burner plate. Also plan to install a single #8 or #10 x 1/2" pan head hold down screw for each dual burner assembly (in one of the punched holes), thought not actually required. An inexpensive investment for a direct swap out for an older range that would other wise have been scrapped. Quality appears to be good, but time will tell. BTW, after a light wire brushing (cleaning) of the spark electrode all four burners light on the fourth (4) click.

i think all the companies that make this replacement burner are missing a small, but important detail. The tubes that the gas goes through to arrive at the pilot for ignition are a little bit too close to each other to fit on certain GE brand stoves. I had to slice a one-eighth sized piece off of the ends of the tubes to fit them around the pilot assembly. I am not advocating that anyone else try this; on the contrary, avoid this potentially dangerous remedy. I am in the industry, and can make such a fabrication safely. if the stove's manufacturer's website says the part is no longer produced, you would then look on Amazon, it's a reflex, and you will find every maker on the planet that dells the part. so, just know before you buy it, that on the very old GE ranges, you will have to trim off about one eighth-of-an-inch of the ends that face each other, or you wont get them to fit.

I am impressed. Raise the stovetop and easy installed, The only thing needed is a Phillips head Skrew driver. Raise stovetop, blow out 2 pilot lights, remove 2 skrews on old and set the rings on the Skrew of stove, set this on stove, then put the 2 skrews you removed back in same places, use lighter or match to light pilot. and bam, finished.

Le dieron un cambio espectacular a una vieja pero aun funcional cocina a gas

Great universal part, now my stove burners work perfectly.

I have a Kenmore 362.72755694 stove and the manual says WB29K0017 is a direct replacement. The photos show that the longer tubes in the replacement block the igniter housing. So for my stove this won't fit. I didn't mind putting the spacers under it but I'm not going to use a hacksaw to cut the pipes shorter.