JLF Repair Kit with HH-66 Vinyl Cement Glue (or Without Glue) for Inflatable Stand Up Paddle Boards (SUP) Includes 3" x 6" Red, White, Blue, Clear, Grey PVC, 5 Patches and 6 Prong Valve Wrench

the kit is great works like it should used on blow up bed. no more leaks.

Does the job

Ordered twice and did not have the wrench as described, error or bad batch? Amazon or JLF has now changed the description to not include wrench. Good job on speedy correction .

The PVC patches are perfect for high use inflatables. The container is great to keep them stored in and protected for future use. My recomendation is to for you to verify what type of Halkey-Robert Valve (aka HR Valve) you have. It will either have 6 key holes or 8 key holes. If you have 8 this wrench will not work for you. However the patches will!

The glue is more like a contact cement and dries too quickly and I would not recommend for any air filled product that does not have a completely smooth surface. I followed the instructions and placed glue on one side of the patch and also in / around the repair area. The glue dries almost instantly (Glue instructions says to wait a minute or two after applying for it to set up). When the patch is applied it sticks great, but the glue is dry at this point and does not squeeze to fill all the tiny voids, which will allow air to escape when you put air in. I followed all instructions and waited 24 hours before putting air in and testing the patch. Maybe this was not meant for Stand Up paddle boards which generally have a rougher texture (not smooth) and take 13 -15 PSI of air. I tried using the patch kit three times, including varying the drying times, and all three times it leaked.

I was shocked that this kit did not include glue

My stand up paddle board had a 2inch split in the side. Using this kit and the H66 glue (not included) it managed to fully repair the board!

Sucks it’s not a complete kit.